Cam Followers - IKO NIPPON THOMPSON America - #2

These are the basic type bearings in H3€0 Cam Follower series. Models with stud diameters ranging from 3 to 30 mm are prepared, and are suitable for a wide range of applications.

The stud of these bearings is eccentric to the center axis of the outer ring. Thus, the position of the outer ring in the radial direction in relation to the mating track surface can easily be adjusted by turning the stud, and the load distribution on a number of cam follower outer rings used on the same track surface can be made uniform.

These are eccentric cam followers with a one-piece stud that can be mounted in the same mounting holes as those for Standard Type Cam Followers. Eccentricity is 0.25 mm ~ 0.6 mm.

In these bearings, an eccentric collar is assembled with the Cam Follower stud, enabling the outer ring to be positioned easily in the radial direction against the mating track surface. Eccentricity is 0.4 ~ 1.5 mm.

These bearings have special resin thrust disk wash­ers superior in wear and heat resistance between the sliding surfaces of outer ring shoulders, stud head and side plate. These disk washers reduce friction and wear due to axial loads caused by misalignment, etc.

These bearings have one or two pipe-threaded holes in the stud. Thus, this series is suitable when central­ized lubrication is required.

These bearings have a stepped tapered portion on the stud. When mounting the Cam Follower, it is easy to fix its location by tightening a set screw to the stepped portion. Thus, this type is suitable when a large number of Cam Followers are used in a machine such as a pallet changer.

These bearings are full complement type bearings incorporating double rows of full complement cylindri­cal rollers in the outer ring, and can withstand large radial loads and some axial loads.

These are compactly designed bearings, incorporat­ing very thin needle rollers in an outer ring with a small outside diameter. They are used in electronic devices, OA equipment, small index devices, etc.

Two types, CR and CRH, are available in the Inch series Cam Followers. Black oxide film treatment is made on CRH models.

For Cam Followers, the types shown in Table 1 are available.

u_

CD

CO u_

-I—' cu

1N=0.102kgf=0.2248lbs.

328