Text version of the page

• Standard Specifications

Model

BELT–Black Monofilament, PVC top with urethane guide strip.FRAME–8-3/8 in. inside, 10-1/2 in. outside. 2” x 2” x 3/16” Structural Steel All Welded Construction.PULLEYS–Tapered with 1-7/16 in. dia. shaft through bearings. Adjustable to control belt tension.BEARINGS–Sealed, pre-lubricated, self-aligning, ball bearings on drive and tail pulley. Re-lube type. MOTOR–3/4 HP Shaft Mounted Right Angle Gearmotor 208/230/460/575V-3Ph. 60 Hz (Specify Exact Voltage).BELT SPEED–Constant 65 FPM at center line of conveying surface. CAPACITY–Maximum load per linear foot (measured at center line of conveying surface) 40 lbs.FLOOR SUPPORTS–Now supplied as optional equipment. See chart below for available elevations.

curved belt conveyor - 7147 TS1500-100

FSK SUPPORTModelNo.OAWAdjustment toTop of Belt FSK-116-1/2"to24-1/2"8-1/2" - 24" FSK-224" - 32" FSK-333" - 41" FSK-442" - 60" FSK-561" - 90" FSK-691" - 120"
FLOW FLOW FLOW FLOW

TYPE A TYPE B TYPE C TYPE D

LEFT HAND CURVE RIGHT HAND CURVE LEFT HAND CURVE RIGHT HAND CURVE OUTSIDE DRIVE OUTSIDE DRIVE INSIDE DRIVE INSIDE DRIVE

STANDARD STANDARD OPTIONAL OPTIONAL

• Optional Equipment

FLOOR SUPPORTS–FSK Type floor supports are available with a wide range of adjustment. Specify top of belt or roller elevation. Supports required at each end and in the center of the conveyor. Holes in feet for lagging to floor. Knee braces recommended above FSK-6 support.BELT SPEED–Up to 200 FPM (shaft mounted), 200 - 600 FPM (timing belt), NOTE: Capacity affected with speed change, see chart above. Higher speeds available, contact factory.DRIVE LOCATION–Drive located inside of curves per drawings C & D. MOTORS–Other HP available, 5 HP maximum (contact factory). BELTS–Types and styles other than standard are available (contact factory).CEILING HANGERS–5/8 in. dia. x 8 ft. long unplated rods fully threaded. Other lengths and galvanized rods available.GUARD RAILS–2 in. to 24 in. tall available for all sizes. ELECTRICAL CONTROLS–Non-reversing magnetic starters and push-button stations. AC variable frequency drive.CUSTOM COLORS–Available (contact factory). Paint chip must be provided.

20 Hytrol Conveyor Catalog #589-Rev. 1 Effective September 2008