angled belt conveyor - HYTROL - (Version JPG) - Page n° 2 - PDF Catalogue | Technical Documentation

See other catalogues for HYTROL

Curved conveyor, Roller conveyor, Mobile conveyor, Gravity conveyor, Chain conveyor

Text version of the page

• Standard Specifications Model PC H

OVERHEAD END DRIVE-Located on discharge end of conveyor. Chain guard located on right hand side.

BELT-Piano Hinge metal belt with 12 ga. plain bottom aprons. 2-1/2 in. pitch chain with 1-1/2 in. dia. hardened rollers with 7/16 in. dia. hinge axle. 1-1/2 in. high x 10 ga. continuous off-set side wing links.

BED-8-5/8 in. deep x 10 ga. powder painted, formed steel channel. Modular bed sections bolt together with butt couplings. 45 ° standard incline section.

BELT GUIDES-Steel angle mounted inside bed for tracking belt.

TAKE-UP-Take-ups are provided to insure proper belt tension.

BEARINGS-Sealed, re-lube bearings at drive and take-up.

SPEED REDUCTION- Sealed worm gear speed reducer driven by V-belt. No. 60 roller chain to drive sprockets.

MOTOR- 1 HP -208/230/460/575V-3 Ph. 60 Hz with torque limiter (Not a warranty item). Totally Enclosed.

BELT SPEED-Constant 30 FPM.

DRIVE SPROCKETS-5 in. pitch dia. with 1-7/16 in. dia. shaft, 6 tooth. CAPACITY-35 lbs. belt capacity per linear foot of conveyor.

TAKE-UP SPROCKETS-5 in. pitch dia. with 1-7/16 in. dia. shaft, 6 tooth. FLOOR SUPPORTS-Now supplied as optional equipment.

Metal Piano Hinge belt provides continuous reliable service. Construction is heavy-duty with perforated apron plates and solid steel, heat-treated rollers.

Model PCH design makes it ideal for positioning into or under punch presses and similar equipment. Horizontal discharge section allows easy positioning of hopper or drum for parts collection.

• Optional Equipment

FLOOR SUPPORTS-PCHS Type floor supports are available with a wide range of adjustment. Specify top of belt or roller elevation. One support required at every bed joint and ends of conveyor. Holes in feet for lagging to floor. Knee braces recommended above PCHS-3 support.

INCLINES-30°, 45°, and 60° angles. Horizontal available. BED-2 ft. through 10 ft. intermediate beds available.


	cleats. Contact factory.	HP maximum.
	DRIP PANS-Mounted underneath conveyor frame for drainage.	ELECTRICAL CONTROLS-Magnetic starters, push button stations and AC
		variable frequency drive.


	COVER-Mounted on top of conveyor frame to keep parts from falling back
	when conveyor is used at steep incline			BELT SPEED-Other constant and variable speeds.

148

Hylrol Conveyor Catalog #589 Effective July 2007

angled belt conveyor - HYTROL - #2

Curved conveyor, Roller conveyor, Mobile conveyor, Gravity conveyor, Chain conveyor