Series 5200 Big Twin Piston Pumps - Hypro Agricultural - #1

The Hypro Series 5200 Big Twin® piston pump is suitable for applications in high pressure washers for industrial and agricultural cleaning needs. It is also useful as a sprayer pump to apply a wide range of chemicals.

The Series 5200 is constructed of cast iron body and cylinder heads, unitized stainless steel valve assemblies and double row ball bearing supported crankshaft. Three cup materials are available to meet specific pumping needs. They are:

Leather-for pumping aromatic solvents and other chemicals damaging to rubber.

Fabric-for pumping most insecticides, herbicides and fertilizers.

Buna-N Rubber-for pumping soap and detergent solutions and some fertilizers.

Two crankshaft options are available—1" solid shaft for belt and pulley or flexible coupling drive, or 1-3/8" hollow shaft for direct mounting onto a 6-spline 540 rpm PTO shaft.

Max. Flow Rate: .... 6 gpm (5206) @ 600 rpm

10 gpm (5210)

Max. Pressure:...................................400 psi

Max. Speed:...........................800 rpm (5206)

600 rpm (5210) Ports:.......................................3/4" NPT inlet

3/4" NPT outlet

Shaft:..................................................1" solid

1-3/8" hollow shaft

6. Secure the discharge lines before starting the pump. An unsecured line may whip, causing personal injury and/or property damage.

7. Check hose for weak or worn condition before each use. Make certain that all connections are tight and secure.

8. Periodically inspect the pump and the system components. Perform routine maintenance as required (see Maintenance section).

9. Protect pump from freezing conditions by draining liquid and pumping rust inhibiting antifreeze solution through the system, coating the pump interior.

10. Use only pipe, hose and fittings rated for the maximum psi rating of the pump.

11. Do not use these pumps for pumping water or other liquids for human or animal consumption.

1. Warning: Do not pump flammable or explosive fluids such as gasoline, fuel oil, kerosene, etc. Do not use in explosive atmospheres. The pump should be used only with liquids compatible with the pump component materials. Failure to follow this warning can result in personal injury and/or property damage and will void the product warranty.

2. Be sure all exposed moving parts such as shafts,couplers and adapters are properly shielded or guarded and that all coupling devices are securely attached before applying power.

3. Pumps mounted directly on to PTO shaft or other power shaft must be prevented from rotating with the power shaft by use of a torque arm. Pump must float freely on the power shaft and must not be tied rigidly to equipment on which it is mounted.

4. Do Not Exceed recommended speed, pressure and temperature for pump and equipment being used.

5. Before Servicing, disconnect all power, make sure all pressure in the system is relieved, drain all liquids from the system and flush.