Catalogs >
Hubix Sp. z o.o. >
Hack-saw

Hack-saw
2Pages

Catalog excerpts

TECHNICAL SHEET HACK-SAW PRODUCER: „HUBIX" CHARACTERISTICS Insulation, red, made of polyamide with the 30% addition fibreglass. Two blade position. Blade has a cover. Tool is controlled and tested (10kV/10s) in accordance with EN 60900:2004. Blade length: 300mm Weight: 730g APPLICATION Live working up to 1000V a.c. and 1500V d.c. Tool is used to cutting constructional elements of electric devices on overhead lines and connecting boxes.. STORAGE AND MAINTENANCE Insulated or insulating hand tools should be properly stored to minimize the risk of damage to the insulation due to storage or transportation. These tools should be stored generally separated from other tools to avoid mechanical damage or confusion. Tool should be prevented from excessive heat and sun light. Use a dry tissue to clean. When tool becomes strong soiled use suitable solvent to clean. CHECK AND PERIODIC INSPECTION Before use, each hand tool should be visually inspected by the user. An annual visual examination by a suitably trained person is recommended to determine the suitability of the tool for further service. The visual check shall be considered successful if: o The tool (in particular the insulation) is free from external defect, o The marking is legible and complete. Don’t use damaged, worn-out (cracks or deep scratches on insulation) or dirty tools in live working. Tool which becomes wet must be dried before use

Open the catalog to page 1

ATTENTION! In case of doubt after visual examination, the routine dielectric test should be preformed. FREQUENCY TESTS For check and periodic inspection to be carried out in according to table. PERIODIC INSPECITON PERIODIC INSPECION CARD supervisor result

Open the catalog to page 2