High-pressure submersible pumps - HOMA Pumpenfabrik - #1

PUMP TECHNOLOGY

100

H(m)

90

80 70 60 50 40 30 20 10 0

HOMA high-pressure submersible pumps are suitable for pumping clear water with high pressure, even from boreholes or narrow wells. They are used for domestic water supply, irrigation, garden watering from cisterns or similiar, in fountain displays, watering place, heat pumps, ground water drainage and so on.

In combination with the electronic cont­rol panel HPS 2 or with a pressure tank, pressure switch and an electrical control panel the pumps can operate automati­cally (see accessories).

Installation: The pumps operate in vertical or horizontal psoition. For vertical operation in a well the pump must be suspended on a rope.

Pumped liquid: Clear water. Max. teperature of the liquid: 35°C.

Operation: permanent (S1)

0 8 16 24 32 40 48 56 64 72 80 88 96 104 (l/min)

I-1-1-1-1-1-i-Q

0 1 2 3 4 5 6 (m³/h)

80 H(m)

70

60 50 40 30 20 10 0

0 8 16 24 32 40 48 56 64 72 80 88 96 104 (l/min) I-1-1-1-1-1-i-Q

0 1 2 3 4 5 6 (m³/h)

Fully submersible drainage pump con­sisting of:

Pump: Multistage centrifugal pump with vertical discharge.

Impeller: Closed multi-channel impellers, spherical clearance 1,5 mm. Wear rings made of stainless steel.

Motor: Fully submersible, pressure tight electric motor, oil-filled. Insulation class F. Motor protection IP 68. Thermal sensors imbedded in the motor winding.

Shaft/bearings: Large diameter stain­less steel rotor shaft, pre-lubricated bea­rings.

Seals: Double shaft seal with mechanical seal and additional shaft

Voltage: 230-240 V / 1 Ph Speed: 2900 rpm

Model WA: With automatic level control HOMA-Nivomatik.

seal ring.

Materials:

H804, H806, H808:

Pump with 20 m of cable, control box

with capacitor, overload protection and

plug.

H802, H812, H816, H818:

Pump with 20 m of cable and plug.

Elastomere

Perbonane