AirForce ® 40i
2Pages

240V Portable Air Plasma Cutter eed to cut steel? Thinking about an oxy acetylene cutting torch to do the job? Consider a plasma cutter. This simple technology uses an electrical arc and compressed air to cut steel, aluminum, and other conductive metals. The AirForce 40i plasma cutter features an inverter design that is both lightweight and powerful. The product also features an ergonomic trigger safety, more efficient air consumption, and economically priced XT40R torch consumables. The 40i requires 240 V, 50 A input power and compressed air delivery of at least 4.8 scfm @ 90 –120 psi. Maximum cutting of mild steel is 7/8 inch at 50% duty cycle for heavy-duty production requirements. Includes: #500566 12-ft. (3.7 m) XT40R hand-held torch 12-ft. (3.7 m) work cable with clamp Extra consumables 10-ft. (3 m) power cord with plug Easy-to-connect, built-in gas/air filter and regulator for extra protection Compared to the complexities of an oxy fuel cutting torch system, plasma cutting is easy: Cuts faster than oxy fuel More precise cut, thinner kerf, less slag to clean up Smaller heat-affected zone for less warping No gas pressure settings or flame tuning needed No preheating of metal prior to cutting Applications: Maintenance Light Construction Prototyping Body Shops/Fabrication Designed for increased comfort with an ergonomic trigger safety, more efficient cooling and economical replacement cutting tips. Allows you to cut expanded/perforated metals, as well as painted or coated surfaces, without retriggering the torch. Wind Tunnel Technology™ Prevents abrasive dust and particles from damaging internal components. Cooling system operates only when needed reducing power consumption and contaminants drawn into the machine. Power factor correction (PFC) circuitry Draws up to 30% less amperage for the same cutting range as compared to the competition. PFC expands operators work area via extension cord, while minimizing nuisance circuit breaker trips caused by voltage drops. LVC™ line voltage compensation Provides peak performance power under variable input voltage conditions (±15%) for steady and cleaner-ending cuts. Internal gas/air filter and regulator Controls amount of usage and flow of air or gas. Starts without high frequency Protects unit by not interfering with or damaging controls or computers. Diagnostic lights LED lights for quick troubleshooting of pressure, power and cup situations. Cable management strap Secures torch, work cable and power cord to make transporting easy and convenient. Postflow cooling circuit Extends life of consumables and torch by cooling them with postflow air after trigger is released. Compatible with engine-driven welders Capable of cutting 3/8–5/8 in. mild steel when powered by an engine-driven welder with a 240 V generator power outlet of 8 kW or more. Hobart’s 5/3/1 Industrial Warranty Five-year warranty on transformers, stabilizers and generators; three years on electronics (drive motors, rectifiers); and one year on guns (MIG and plasma torches). Specifications (SUBJECT TO CHANGE WITHOUT NOTICE.) Rated Output 40 A with 140 VDC, 50% Duty Cycle Amps Input at Rated Output, 50/60 Hz, 1-Phase 208 V 230 V KVA KW Certified by Canadian Standards Association to both the Canadian and U.S. Standards.

Mild Steel Cutting Capability (THICKNESS TO SCALE.) Maximum Cutting Speeds at 40 Amps Output Thickness 1/8 in. (3.2 mm) To determine the maximum rated cutting thickness of mild steel, follow the line from the 10 IPM (inches per minute) point on the cutting chart. The point at which this line intersects the cutting curve determines the maximum recommended production cutting thickness of the unit. Note: The rating is based on 10 IPM because this is the minimum speed at which the operator achieves a smooth, steady cut when using a hand-held torch. *Travel speeds are approximately 80% of...