Installation and Safety Manual for Bellows, Spiral Springs, Roller Covers with or without Enclosure, Telescoping Steel Way Covers - HEMA Maschinen- und Apparateschutz - #1

!

■ DURASPRING coil springs must be cleaned at regular intervals. Whenever possible, only DURASPRING oil spray (order no. 80-05-0001) must be used for cleaning and lubricating.Viscous, resinous oils can clog the coils and fracture the spring and are therefore unsuitable. The use of unsuitable lubricants renders the warranty void.

The coil spring is under constant tension!

Remove the wires as described below under "Installation" only after the coiled

Risk Of Injury spring has been fitted over the shaft!

The coil spring must be used only together with the part to be protected, i.e. a ballscrew, etc., other­wise it can snap out unexpectedly and cause griev­ous injury!

DURASPRING coil springs operate optimally in oily environments. In environments with fine particles or

larger dust accumulations, e.g. from wood process­ing, bellows must be used instead.

Our warranty for DURASPRING coil springs

extends to material and production defects only. Our warranties do not extend to damage incurred

as a result of improper installation, loading, and fail­ure to service or clean, e.g. swarf accumulation. Our

general terms and conditions are available as a

download at www. hema-schutz.de 1. Installation

■ Before installing the coil spring ensure that the

flanges on the machine have the tolerances spec­ified in the catalogue.

■ The coil spring must be installed in accordance

with the mounting label H (horizontal) or V (ver-tical).When installed vertically the spring's larger

mounting diameter is uppermost.

■ The wires must not be removed until after the

coil spring has been installed at its intended posi­tion and the flanges are about two to three coil strip widths apart.

■ Remove all of the wiring.

■ After removing the wiring insert the coil spring carefully into the flange receiver. Do not let the coil spring snap out!

■ Note: When installed DURASPRING coil springs must move freely and must not be screwed or riveted!

Our services for you - The order number specified on your DURASPRING coil spring is given below. File this sheet for reference so that you can quickly access the information for replacements.

SFDD

OPENCAREFULLY-RISK OF INJURY !

OIL AND CLEAN REGULARLY!

PHONE +49-(0)

-6182, -77 30, FAX-773 35

INTERNET WWW.HEMA-GMBH.COM

Maschinen- und Apparateschutz GmbH Seligenstädter Straße 82 D-63500 Seligenstadt

tel.+49-(0)6182-773-0 fax+49-(0)6182-773 35 E-Mail: info@hema-schutz.de Internet: www.hema-schutz.de