HMC - HeiMotion Compact servo drives
17Pages

Introduction Contents General information Are you looking for a servo drive system satisfying your high expectations of quality and reliability, which was developed using latest technologies and simultaneously improves your machine in economical terms? If so, this catalogue is the right choice for your applications. Our HeiMotion Compact series of brushless AC servo motors includes eight powerful servo motors and 2 matching motion servo drives families, equipped with different functionalities. Depending on the motor application, you have the choice in between the servo drive familie of HCJ....

General data Ambient conditions & technical characteristics Abbreviations & definitions Motor type Permanent magnet three-phase synchronous servo motor Ambient operating temperature Rated frequency Ambient storage temperature Stall current per phase (motor current at stall torque M0) < 90 % relative humidity (without condensation) Rated current (rated current per phase) Insulation class Peak current (maximum permissible current per phase) Protection class IP65 (standard version), (except drive end, protection class is IP54, without shaft oil seal) Natural convective Bearing lifetime 20,000...

Life span Order code Shaft loading forces Life span of the motors is at least 20,000 hours if operated under rated conditions.The table below shows admissible radial forces for the bearing load. Point of force application is in the middle of the shaft (see drawing). HMC08-028-320-30-B0H1M Frame /flange size 60 mm 80 mm 130 mm Options Without Brake 24 VDC Brake 24 VDC Without Feather key Feather key Resolver SEK 37 SEL 37 Stall torque Maximum radial force Fr, [N] 1,000 Flange dimension 80 mm Rated power 2.8 Nm DC bus voltage 320 V Rated speed 3,000 rpm Options: With brake Without feather key...

Center bore with axial thread according to DIN 332 - DS M4 (M4 x 10) at C=11 or DS M5 (M5 x 12.5) at C=14

Center bore with axial thread according to DIN 332 - DS M6 (M6 x 16)

Center bore with axial thread according to DIN 332 - DS M6 (M6 x 16)

Center bore with axial thread according to DIN 332 - DS M8 (M8 x 19)

Center bore with axial thread according to DIN 332 - DS M8 (M8 x 19)

Center bore with axial thread according to DIN 332 - DS M8 (M8 x 19)

Connectors Dimensions connector and mating connector Motor connectors The HMC06 and HMC08 motors are connected via a shielded cable with a maximum temperature admissibility of 155 °C for the insulation of the individual wires, and 125 °C for the coat. The HMC13 motors are in standard equipped with connectors.The mating connector is not included in the standard version. Straight version copper wire mesh tinned Standard cable length [mm]: Signal cable Pin assignments on the motor Leistungsstecker Signalstecker Power connector Signal connector copper wire mesh tinned 4 Conductor (copper,...

Technical data subject to change! Last changes: 01/2021 Heidrive GmbH Starenstraße 23 D-93309 Kelheim Phone +49 9441/707-0 Fax +49 9441/707-259 info@heidrive.com www.heidrive.com