Catalogs >
HAIDA EQUIPMENT CO., LTD >
Cookware testing proposal

Cookware testing proposal
5Pages

Catalog excerpts

Product brochure ------cookware testing series HAI DA INTERNATIONAL EQUIPMENT CO .，LTD Address: The 1st Industry Area of Caibai, Daojiao Town, Dongguan, Guangdong, China Telephone: 86-13192005939 Email:manager@qctest.co m Contact Person: Ms. Shelly Zhou Showroom: http://www.haidatestequipment.com /

Open the catalog to page 1

TT-007 Cutlery and table hollowware corrosion resistance tester Main parameters: a) Water temperature maintain at 60+/- 2 degree C. b) 24 hours Timer to set and control the test period. c) Cycle speed controllable from 2~5 cycles per minute. d) Tank body made ofPVC. e) Ceramic heater was used for heat source. f) Pneumatic cylinder was used to lift up and down the fixture rack. The equipment is designed to stimulate the cumulative corrosion conditions a knife would experience in typically 2 or 3 years. It will detect overheating of blades caused by grinding

Open the catalog to page 2

TT-M003 Strength test apparatus for knives, carving forks & spatulas Main parameters: a) The apparatus consists 2 clamps, one permanent clamp for the handle and the other removable b) Hand lever of the apparatus is removable and easy to attach on the apparatus. c) 2 set of load included , one is 20 N and the other one is ION (20 N+10N ■ 30N) d) The apparatus is made of aluminum profile and stainless steel. f) Acrylic protective cover provided for safety operation. Theequipment is designed to test bending strength ofcookware, such as spoon, dessert spoon, meal spoon, dessert knife, meal...

Open the catalog to page 3

TT-M001 Torque resistance test apparatus The machine is used to perform torque strength of handle, the distortion at each direct cannot over 10 degree, also not affect the function under normal use Based on Standard BSEN 12983-1 Main parameters: a) Servo motor actuator generate a maximum vertical force of 250N b) A 300N force sensor was used to measure and control the force apply c) Load apply gradually without shock, to the handle until the load is supported or record the peak force when the fixing system fails.

Open the catalog to page 4

TT-M003 Bending strength tester The equipment is used to test bending strength of handle, under specify load on handle slowly, check the fastness of connection between two Main Parameter: a) Servo motor actuator generate a maximum b) A 300N force sensorwas used to measure and controlthe force apply. d) Fixture: tensile and bend fixture each one

Open the catalog to page 5