Split Frame O.D. Mount Tool Catalog - 15.9 2184.4 mm - 8 Pages

  1. P. 1

  2. P. 2

  3. P. 3

  4. P. 4

  5. P. 5

  6. P. 6

  7. P. 7

  8. P. 8

Catalogue excerpts

Split Frame Clamshells and Accessories

 Open the catalogue to page 1

Sever and Machine Pipes From .625" to 72" (15.9 mm to 1828.8 mm) •Rigid And Easy To Handle - Aluminum Body Gives Highest Strength-To Weight Ratio And Our Exclusive Ring Mounted Bearing Design Has A Patent Pending •Lower Overall Investment - Complete Parts Interchangeability Between Models Within Series •Greater Reliability - Our Unique Motor Drive Is Protected by U.S. Patent #7,690,283 B1 • asy Setup And Accurate Cuts E Improved Tool Slide Design •Low-Clearance Design •Patent Pending Safety Tripper Mechanism •Adjustable Locator Pads Have 3/4" (19 mm) Clamping Adjustment Per Pad Which Minimizes...

 Open the catalogue to page 2

F Tool Slide Swing Radius F= Pneumatic MFC-2 = 2.670" 67.8 mm AFC-4, -6, -8 & -10 = 9.1” 231.1 mm AFC-12 & Larger = 11.0” 279.4 mm Electric = 15.1” 383.5 mm Hydraulic = 6.9” 175.3 mm (D-Width) *The MFC's design is unique and has substantially different parts and accessories than the AFC and BFC. The drawings above do not reflect the actual appearance of the MFC and are intended solely for transmitting dimensional data. AFC Series Nom. Pipe Model Size A B 1" Slide 2" Slide 3" Slide 4” Slide 7” Slide Locator Swing Swing Swing Swing Swing Pads

 Open the catalogue to page 3

MFC Locator Extensions Coverage RANGE STANDARD 1/2" AFC Locator Extensions Coverage

 Open the catalogue to page 4

10" Tool Slide Maximum Swing 7" Tool Slide Maximum Swing 4" Tool Slide Maximum Swing C = 5.4" 137.2 mm D = 3.6" 91.4 mm E = 7.2" 182.9 mm F= Pneumatic = 11" 279.4 mm Electric = 15.1" 383.5 mm Hydraulic = 6.9" 175.3 mm BFC Locator Extensions Coverage* *All locator extensions over 4" (101.6 mm) are achieved by combining other sizes (i.e. 7" [177.8 mm] can use a 4" and 3" [101.6 and 76.2 mm] or a 4", 2" and 1" [101.6, 50.8 and 25.4 mm]).

 Open the catalogue to page 5

Counter Bore Heads Tool Slides The H&S tool slides are ruggedly built for strength and durability. Four cap screws are all that are required to securely mount the slides. This dramatically speeds and eases tool slide mounting and locating. Standard sizes are 1", 2", 3", 4", 7" and 10". Other sizes are available. Out-ofround and axial-feed tool slides are also available. Motor Adapters Adapters are available to mount the motor out the front or at a right angle to the frame for work in congested areas. The patent pending H&S motor adapters eliminate the need for additional motors and conversion...

 Open the catalogue to page 8

All H&S Tool, Inc. catalogues and technical brochures