XL 3210II - GRADALL industries Inc - #2

Tracks counter-rotate to pivot machine about the swing centerline. Electronically operated travel alarm signals crawler movement in either direction.

Dual range, high torque piston motor powers each track. Three-stage planetary drive with integral speed limiting valve and automatic spring-set/hydraulic release wet disc parking brake.

Travel Speed on flat, level surface: High Speed: 3.3 mph (5.3 km/h) Low Speed: 1.9 mph (3.1 km/h) Automatic two-speed control shifts crawler drive into low speed under difficult travel conditions. Manual override switch for loading the machine for transport.

100%, limited by engine lubrication requirements.

Approximate working weight with 36" (914mm) excavating bucket, fuel tank half full, and no operator:

20,150 lb (90kN)

17670 lb (79kN)

208,000 in.lb. (23.6 kNm)

4.2 rpm

Shown with Rammer S 27 Hammer and Hammer Bracket (Meters shown in parentheses)

A Overall length with hammer: 2211" (6.9)

B Overall height with optional lift hook: 1210" (3.9)

Bi Overall height without optional lift hook: 10'5" (3.2)

Ci Width of upperstructure: 8'6" (2.6)

D Minimum clearance, upperstructure to undercarriage: 5" (0.127)

E Swing clearance, rear of upperstructure: 7'6" (2.3)

F Top of cab guard to groundline: 10'5" (3.2)

G Clearance, upperstructure to groundline: 3'4" (1.0)

Ji Axis of rotation to centerline of drive sprockets: 47" (1.4)

J2 Nominal distance between centerlines of drive sprockets

and idlers 9'2" (2.8)

Ja Axis of rotation to end of track assembly: 510" (1.8)

J4 Nominal overall length of track assembly: 11'8" (3.5)

K Width of crawler with 23.6" (600mm) pads: 8'6" (2.6)

K Width of crawler with 19.7" (500mm) pads: 8'2" (2.5)

N Ground clearance (per SAE J1234): 1'6" (0.4572)

V Track gage, roller centerline to roller centerline: 6'6" (2)

Y Width of crawler track assembly (standard): 23.6" (0.6)

Y Width of crawler track assembly (optional): 19.7" (0.5) AQ Boom pivot angle: 32° Up & 75° Down

AS Attachment pivot angle: 165°

AU Maximum telescoping boom length (boom pivot to

attachment pivot): 23'0" (7) AV Minimum telescoping boom length (boom pivot to

attachment pivot): 12'0" (3.6) AW Telescoping boom travel: 11'0" (3.4) AX Boom tilt angle (continuous): 360° BA Maximum radius of working equipment: 31'6" (9.6) BG Maximum height of working equipment with hammer

below groundline: 13'4" (4.1)

®

406 Mill Ave. SW, New Philadelphia, Ohio 44663 Phone: 330-339-2211 Fax: 330-339-8468 www.gradall.com

Form No. 10701 2/07 Printed in USA

Certified ISO 9001