| Ultra Series UP25 Ultra Power and Ultra Performance are what you get with our new UP series detectors. Ultra performance means fast. Ultra performance means flexible. They come ready to mount on a rod, a bracket and the square case even lets you set them right on the table. Ultra performance means expandable. We can easily increase the power capability of your modular UP series detector as your needs change. Ultra performance means accurate. It is hard to do better than our NIST traceable calibration and Personal wavelength correction™. Ultra performance means versatile. For all models you can measure pulse energy as well as power (in energy mode). Fiber optic adapters are available, and the Ultras are compatible with all Gentec-EO monitors. A UP series detector is the best choice for many applications. The UP25N Family This family was designed for beams a little too large for the ultra compact UP19K's. Stand alone they handle 40 W. Raise that to 100 W with the heatsink. Go to 250 W with a fan and with water cooling, 300 W in a package that is only 44 mm deep! The UP25Z Family NEW This family is more compact than the UP25N series. It is offered in two models: stand alone up to 15 W and with a water module up to 200 W. New Disk and Absorber The Ultra performance of the UP detectors comes from new disk technology developed at Gentec-EO for both power and speed. Our modular body and cooling modules make it the most versatile detector family available. Moreover, our new H9 absorber is one of the most damage resistant available today. OEM Ultras The large Ultra family accommodates a wide range of OEM requirements. Use a Gentec-EO monitor or your own electronics (requires our internal circuit board). We offer several output connector options. The BNC output gives you fast, easy installation and the best EMI noise shielding. The Molex connector allows you to unplug the detector for service or for use at other locations. The DB-15 contains an EEPROM with the custom calibration data used by Gentec-EO power meters. There are 3 output signal options: 1. Natural voltage from the thermopile, 2. Adjusted to a specific sensitivity, 3. Amplified. Please contact us for the specs on the OEM versions with the internal circuitry. If you don't see exactly what you need, we will provide you with a custom solution. |