catalogue search
P. 01
P. 02
P. 03
P. 04
P. 05
P. 06
P. 07
P. 08
P. 09
P. 10
P. 11
P. 12
P. 13
P. 14
P. 15
P. 16
P. 17
P. 18
P. 19
P. 20
P. 21
P. 22
P. 23
P. 24
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
You may also be interested in
Liquid level switch, Pressure sensor, Ultrasonic sensor, Paddle-wheel flow-meter, Pressure switch
Text version of the page
| | |||||||||||
| | SHUTTLE TYPE | | |||||||||
| | |||||||||||
| Versions | Contents | Page Start | |||||||||
| | |||||||||||
| BONNET | |||||||||||
| | |||||||||||
| SHUTTLE | The FS-400P Series is an inexpensive alternative for plastic piping systems. Units are available in clear PVC housings. The clear version, with a bright red shuttle, provides highly visible affirmation of flow status. Low-cost, all PVC versions are for use in systems where liquid pressures are below 120 PSIG and temperatures do not exceed 120°F. An easily removed, one-piece bonnet and shuttle assembly for quick clean-out is featured. | FS-200 Series General Purpose, Straight-Through Flow Path.....................G-18 FS-200 Series Adjustable Externally Adjustable Actuation Set Point.......................................G-18 FS400 Series General Purpose, 90° Flow Path.............G-20 FS400 Series Adjustable Externally Adjustable Actuation Set Point.......................................G-20 FS400P Series Low-Cost, All PVC..........................................G-21 FS-500 Series Low-Cost, All Polypropylene...................G-22 | |||||||||
| HERMETICALLY SEALED SWITCH | HOUSING | ||||||||||
| Typical Bonnet and Shuttle Removal While a slight accumulation of foreign material within shuttle type units will not affect operation, 150 micron filtration is suggested. Any sizable amount of contamination should be removed. Removing the bonnet nut on FS-200, and FS-400 Series units allows the shuttle assembly to be removed for cleaning without disturbing the installation. Sliding keys on the FS-400P are removed, or the bonnet is twisted on the FS-500, for the one-piece bonnet/shuttle to be lifted out of its housing. Consult the factory for replacement parts. Damaged electrical components must be replaced at the factory. | |||||||||||
| | |||||||||||
| FS-400P Series | FS-500 Series | ||||||||||
| | |||||||||||
| LOCKING KEYS SLIDE OUT TO RELEASE | BONNET AND SHUTTLE LIFT / OUT OF X HOUSING | BONNET IS RELEASED WITH A COUNTERCLOCKWISE TWIST | BONNET AND SHUTTLE LIFT OUT OF HOUSING | | |||||||
| BONNET | |||||||||||
| WO LU WO O _i Ll_ | | ||||||||||
| HOUSING STAYS IN PIPING SYSTEM | HOUSING STAYS IN PIPING SYSTEM | ||||||||||
| | |||||||||||
| Visit www.GemsSensars.com for most current information. | G-17 | ||||||||||
| | |||||||||||