TR
transducers are supplied with the adaptor flange for fixing, with 4 M6 screwsor with one central M10 or M12 screw.
TR series force transducers are used to measure the tension that plastic filmsor tapes exert on the
guide rollers of the machinery used to coil them.
Mounted at the ends of a fixed or transmission shaft on the machine chassis,
they perform the function of force sensors and bearing for the ends of the shaft. They are used on both fixed and rotating shafts. EXTRUDERHopper Main features • Range of measurement: from 100 N to 1kN?Accuracy class: 0,5%
?Corrosion resistant
?Internally generated calibration signal
?Orientation of the axis of maximum sensitivity for 35°independentlyfrom the position of the fixing holes?Grade of protection: IP65 (DIN 40050)
?Integrated protection against overloads
Cells ControllerDrive + Motor Film die Stripp i OC series low profile load cells are used inweighing machines for piece counting, bottling,
dosing, weighing parcels, fiscal weighing,
pharmaceutical weighing, etc. roll OC load cell is the heartof the mechanical design.
Infact they provide automatic compensation for
eccentric loads on platforms up to 400x400mm
without the need of mechanical calibrations.
The
Air knife Chill roll The OC series load cells have been designedfor all applications requiring accurate weighing of
loads on a platform, as well as for general
applications in conformity with the OIML
standards.
In all these cases, the Edge trim slitter Thic k OIMLR60 Certificate nr. TC2330 Main features ?Range of measurement: from 5 to 100 kg?Accuracy class: C (OIMLR60)
?May be mounted directly on the
weighing platform
?Humidity resistant: conform to OIMLR60
?Low cost
?Applicable Platform: 400 x 400 mm
?Certified by NMI Institute according to: