Integrated: 100 to 500 µm (5 to 20 mils) peak to peak Filters Input Impedance Bias Voltage: Vibration Variables: 3-wire Voltage Mode: -24 V Accuracy Bias Filter: Vibration Variables: Vibration: 0.5 Hz to 5.5 kHz, configurable 8-pole high-pass, 4-pole low-pass 10 k Velocity and Reciprocating Velocity Channel Type Full Scale Range 0.09 Hz 1-pole low-pass 10 to 50 mm/s (0.5 to 2 in/s) peak and RMS Velocity Variables and Reciprocating Velocity Variables are filtered and processed measurements from raw transducer signals. The Velocity Channel Type and Reciprocating Velocity Channel Type support up to four continuously calculated variables per channel. ±1% of full scale range Up to three bandpass filtered amplitude measurements. Velocity Variables and Reciprocating Velocity Variables The Velocity Channel Type and Reciprocating Velocity Channel Type support two-wire and three- wire piezo-velocity sensors. 2.4 kHz 1-pole low-pass Input Impedance Vibration: OK Filter: Bias Voltage: 3-Wire Voltage Mode: Users may assign the value of the transducer bias voltage to any of the variables. 10 k Configurable Options Radial Vibration Channel Type Vibration Variables: Each variable is independently configured with the following options. The Radial Vibration Channel Type measures radial shaft motion using proximity sensors. Radial Vibration Variables Peak or RMS Radial Vibration Variables are filtered and processed measurements from raw transducer sensors. The Radial Vibration Channel Type supports up to four continuously calculated variables per channel. Metric or English units Filter corner frequencies Full-scale range Velocity integrated to displacement
Specifications and Ordering Information Part Number 173401-01 Rev. E (04/07) Page 4 of 20