SprintIR - 2 Pages

  1. P. 1

  2. P. 2

Catalogue excerpts

SprintlR™High Speed Carbon Dioxide Sensor SprintIR is a high speed (20 Hz) CO2 sensor, ideally suited for applications which require capture of rapidly changing CO2 concentrations including metabolic assessment and analytical instrumentation. • High speed sensing (20Hz) • Measurement ranges from 0 to 100% •    3.3V supply • Low power requirement 35mW • Flow through adaptor (Optional) SprintIR™ Sensor SprintIR™ Sensor www.gassensing.co.uk © GSS Ltd 2016 Information supplied by GSS Ltd is believed to be accurate and reliable. However, no responsibility is assumed by GSS Ltd for its

 Open the catalogue to page 1

Warm-up Time Electrical/ Mechanical Power Input Dimensions and Wiring Connections 2x5 0.1" header. Pin 1 is identified on the dimensional Pin 2 should not be connected. Pins 4 and 6 do not require connection and are internally connected to GND. The zeroing options are for hardware zeroing (both active low). These functions can also be implemented by sending a serial command (recommended). Typical connections for digital interface are GND, 3.3V, Rx and Tx. Note that the Vh for the serial Tx line will be 3V regardless of the supply voltage. Note 1: All measurements are at STP unless otherwise stated....

 Open the catalogue to page 2

All Gas Sensing Solutions (GSS) catalogues and technical brochures

  1. SHT21

    12 Pages

    En
  2. MinIR™

    2 Pages

    En
  3. MISIR™

    3 Pages

    En
  4. SprintIR™

    2 Pages

    En