Text version of the page

PORT CONNECTORS: POWER INPUT: RJ-45 with auto-cross, 100BASE-TX and 10BASE-T: shielded 8-Pin female. Supports shielded (STP) and unshielded (UTP) Cat. 3, 4, 5. PoE power is delivered to the unused (spare) twisted-pair port pins. Total Power Consumption: 66 watts max. (1.4A @48VDC). Terminal block for

4 port PoE Power Source Switch - 37512 Specifications Specifications

MOUNTING FOR PS14P FAMILY OF SWITCHES: PACKAGING: Metal panel mounting clips: included DIN-Rail mounting option:Model # DIN-RAIL MC2, illustrated here;Rack-mount option: Model MC14-TRAY.Depth: 6.0", Width 17", Height 2.25"(15 cm D x 43cm W x 5.7cm H)

Magnum PS14P Power Source Switch

Enclosure: Robust sheet metal (steel) Dimensions of units: 3.5 in H x 3.0 in W x 1.0 in D (8.9 cm x 7.6 cm x 2.5 cm) Weight: PS14P Switch Units: 9.6 oz (272 grams) Cooling Method: Case used as a heat sink LED INDICATORS (dual, front and end, port #4 front only): POWER: ON for -48V power applied to the PS14P unit PoE, ports 1,2,3,4: ON when delivering power 10/100 per port: Steady ON for 100 Mb speed, OFF for 10 Mb speed LK/ACT per port: Steady ON for LINK w/no traffic, blinking for Activity. F/H per port 1,2,3 in end: Steady ON for F/D mode, OFF for H/D mode PERFORMANCE: Data Rate: 10 / 100 Mb, FDX and HDX modes on all 4 ports. Auto-negotiation and auto-cross MDI-MDIX on all four RJ-45 ports Occurs at LINK-enable. No cross-over cables required.Non-blocking switching, 128KB packet buffer memory Address buffer storage = 2K addresses Address buffer age-out time = 300 seconds OPERATING ENVIRONMENT: NETWORK STANDARDS: Ambient temperature ratings of –40°C to 75°C long term per independent agency tests, or –40°C to 85°C short term per IEC Type Tests. Storage temperature: -40° to 185°F (-40°to 85°C) Cold start to -40°C Ambient Relative Humidity: 5% - 95% (non-condensing) Altitude: -200 to 50,000 ft. (-60 to 15,000m) Conformal coating (humidity protection) optional, request quote. Designed for NEBS compliance, including vibration, shock, and altitude. Ethernet IEEE 802.3af PoE; IEEE 802.3, IEEE 802.3u; IEEE 802.1p, 100BASE-TX, 10BASE-T Data packets that have the 4-bytes tagged VLAN field (IEEE 802.1q) inserted in them are received and transmitted unchanged by all PS14Ps. -48V DC input (range of 46 to 60V DC), built-infor +, -, ground. The 8-15V DC jack is also present, but can only be used to power the PS14P unit when no PoE devices are attached. PS14P terminal block area, shown with panel mount bracket. POWER OUPUT: PoE available on all four RJ-45 ports viaEthernet twisted pair cabling on port pins 4,5(+), 7,8(-). Uses spare pairs, not data pairs. 802.3af Power Consumption: 61.6 watts max. (15.4/port) PoE Ports Output voltage: 44 to 57 VDC Over-current Protection, per port: resettable fuse WARRANTY: Three years Made in USA1: These products are tested and approved under IEC61850 for usein Class C sheltered locations where neither temperature nor hu- midity are controlled. The equipment needs to be protected against solar radiation, rainfall, other precipitations, and wind. UL has not approved these products for Annex-T outdoor use.
AGENCY APPROVALS AND STANDARDS COMPLIANCE: UL listed (UL60950), cUL, CE, Emissions meet FCC Part 15, Class A.(see footnote 1) NEBS L3 and ETSI compliant IEEE 1613 Env. Std for Electric Power Substations NEMA TS-2 and TEES for traffic control equipment IEC61850 EMC and Operating Conditions Class C for Power Substations Designed for above-the-ceiling (plenum) installation
ï›™ 2005 GarrettCom, Inc. Printed in United States of America Doc No. R1 PS14P-4/05GarrettCom, Inc. reserves the right to change specifications, performance characteristics and/or model offerings without notice. GarrettCom, Magnum, Personal Switch, Link-Loss-Learn, S- Ring, Convenient Switch and Converter Switch are trademarks and Personal Hub is a registered trademark of GarrettCom, Inc. NEBS is a registered trademark of Telcordia Technologies. UL is a registered trademark of Underwriters Labs.

Typical Applications:

Connect a VoIP phone, a PoE powered digital clock, and an IP badge reader in an outdoor guard station into an indoors LAN using standard Ethernet twisted-pair copper cable Connect an IP wireless access point in a warehouse into the factory LAN For surveillance, connect a couple of outdoor PoE video cameras into a secure LAN Same as previous, but combine with a Magnum CS14P-48VDC for a fiber optic up-link

Ordering Information

Magnum PS14P

Magnum Premium-rated PoE Power Source Convenient Switch, four 10/100 RJ-45 ports in a compact package, rated for temperature un-controlled (outdoor) envi-ronments. All four RJ-45 Ethernet ports support Power Source PoE per the IEEE 802.3af standard. Includes integral -48V DC terminal block for power input. Note - should a heavy-duty industrial power supply be desired, that plugs into AC and delivers -48VDC at50+ watts to support one PS14P-48VDC Switch and up to 4 attached PoE devices, check web sites such as www.LANstore.com. GarrettCom, Inc.
47823 Westinghouse DriveFremont, CA 94539PH: (510) 438-9071FAX: (510) 438-9072Email: mktg@garrettcom.comWeb: www.GarrettCom.com