Specifications Specifications

16-port Ethernet 10/100 SwitchModel 4K16

PERFORMANCE:RJ-45 Ports: DC DUAL POWER SOURCE (OPTIONAL) 100 or 10Mbps, full- or half-duplex mode, per port,individually determined. 10/100 auto-negotiating, fdx/hdx, internaljumper can select 100-only The Magnum 4K16 may be ordered with optional Dual DC powerinput, for continuity of operation when either one of the DC inputsources is interrupted. Available for -48VDC, 24VDC, and 125VDCinput types. Fiber Ports (m.-mode and sgl.-mode) : 100Mb speed per port basedon the fiber connector part. FDX or HDX selection, default is FDX. All Ports: Processing type: Non-blocking, Store and Forward withIEEE 802.3x full-duplex flow controlSystem aggregate forwarding rate: 2.3M pps (all ports100Mb speed) System (16p) aggregate filter rate: 2.3M ppsfor all ports.Address table: 32K nodes, self-learning, with address agingPacket buffers: 2MB dynamicLatency: 5 MECHANICAL: Enclosure: Rugged high-strength sheet metal. Suitable for stand-alone or 1U rack mounting.Rack-mounting brackets: 19” included; ETSI and 23” Telco optional.Cooling Method: Fan cooled, internal, on chip.Dimensions: 1.75 in H x 17.0 in W x 9.0 in D 4.45 cm H x 43.2 cm W x 22.9 cm DWeight: 7.1 lb. (3.2 kg) µ s + packet time max (TX - TX, TX - FX, FX - FX), PDV: 50BT NETWORK STANDARDS: SWITCHES ON CHASSIS, MANUAL: IEEE 802.3u: 100BASE-TX, -FX, IEEE 802.3: 10BASE-TAuto-negotiation on TP, IEEE 802.3uAll 10Mb ports obey the rules for configuring 10Mb Ethernet. All100Mb ports use Fast Ethernet rules Power ON/OFF, standard AC modelsFull/half duplex on fiber ports. LED INDICATORS ON CHASSIS: POWER: Steady on when power appliedERR: Self-test at power up failed.Reverse Model Option Available: Reverse models are designed withthe LED indicators in the front and all wiring and power connectionsin the rear, normally rack-mounted. OPERATING ENVIRONMENT: Ambient: 25° to 140°F (-5° to 60°C), optional extended rangeStorage: -40°to 185°F (-40°to 85°C)Ambient relative humidity: 5% to 95% (non-condensing)Altitude: -200 to 13000ft (-60 to 4000m)Conformal coating (humidity protection) option: Request quote LED INDICATORS PER PORT: Link/Act: Steady ON for LINK with no traffic, blinking indicates portis transmitting and receivingSPEED: ON=100, OFF=10Mb/sF / H: Steady ON for Full duplex, OFF for Half duplex. UP-LINK, PORT #1: Thumb-operated slide switch, converts Port #1 from a regular(= position) port to a crossover (X position) Up-Link for on/offconnection to an upstream or cascaded hub or switch. LED INDICATORS, FIBER PORTS: NETWORK CABLE CONNECTORS: The 1 or 2 fiber ports, when present, render the correspondingcopper ports inoperative. LEDs for fiber ports have thesame meaning as for copper ports. RJ-45 shielded female ports100Mb: Category 5 UTP/STP 10Mb: Cat. 3,4, 5 UTPFiber ports: Zero, One or Two / unit.Connector options: Multi-mode FX-ST, SC, MTRJ; Single-mode 20KmSC, and 40Km "long reach" single-mode SC. AGENCY APPROVALS: UL Listed (UL60950), cUL, CEEmissions meet FCC Part 15, Class BOptional: ETSI and NEBS L3 Certified AC POWER SUPPLY MANUFACTURER (INTERNAL): AC Power connector: IEC-type, male recessed, ON/OFF switch.Power Input Voltage: 100 - 240 VAC (auto ranging)Power Input Frequency: 47 to 63 HzPower Consumption: 19 Watts typical, 25 Watts max with FKM WARRANTY: Three years Made in USA INDUSTRIAL DC POWER SUPPLY OPTIONS:-48VDC: Input -36 to -70VDC
ï›™ 2005 GarrettCom, Inc. Printed in United States of America Doc No. 4K16-R5 3/05. GarrettCom, Inc. reservesthe right to change specifications, performance characteristics and/or model offerings without notice. GarrettCom, Magnum, Personal Switch, Link-Loss-Learn, S-Ring, Convenient Switch and Industrial converter Switch are trademarks and Personal Hub is a registered trademark of GarrettCom, Inc. NEBS is a registered trademark of Telcordia Technolo- gies. UL is a registered trademark of Underwriters Labs. 24VDC: Input 20 to 40VDC 125VDC: Input 120 to 160VDCStd. Terminal Block: "-, GND, +", Power Consumption: Same as AC

Ordering Information

Magnum 4K16 Ethernet Switch with 16 RJ-45 ports, each auto-sensing for 100Mb / 10Mb FDX / HDX operation. Optional fiberports may be configured, one or two from the family of modules below, to operate at 100Mb in place of one ortwo RJ-45 ports. User-selected fiber port connector types. Each port is switched and provides a full-speedtraffic domain with non-blocking performance. Includes internal auto-ranging power supply, cooling fan, andmetal brackets for rack mounting. LEDs and user ports are in the front, power input is in the rear. Requestquote for units with DC input. Magnum 4K16R “Reverse” model, same as Model 4K16 except user ports and the power input connectors are in the rear. Fiber Port Modules (for 4K-Series Switches, Models 4K16 and 4K24F): GarrettCom, Inc.
FKM-1SCFiber module with one 100Mb multi-mode FX SC connectorFKM-1STFiber module with one 100Mb multi-mode FX ST connectorFKM-1MTRJFiber module with one 100Mb multi-mode FX MTRJ small form factor connectorFKM-1SSCFiber module with one 100Mb 20Km single-mode FX SC connectorFKM-1SSCLFiber module with one 100Mb 40Km “long reach” single-mode FX SC connectorFKM-2SCFiber module with two 100Mb multi-mode FX SC connectorsFKM-2STFiber module with two 100Mb multi-mode FX ST connectorsFKM-2MTRJFiber module with two 100Mb multi-mode FX MTRJ small form factor connectorsFKM-2SSCFiber module with two 100Mb 20Km single-mode FX SC connectorsFKM-2SSCLFiber module with two 100Mb 40Km “long reach” single-mode FX SC connectorsFKM-BLNKBlank module with no fiber 478 23 Westinghouse Driv eFremont, CA 94539PH: (510) 438-9071FAX: (510) 438-9072Email: mktg@garrettcom.comWeb: www.GarrettCom.com p orts , included in 4K16 Switch unit when no fiber p ort o p tion is selected or confi g ured.