Pallet locating station
Pallet locating station
Pallet PalletBracket for proximity switch 269,5 (A)268,0 (B)158
30421011236132 269,5 (A)268,0 (B)158
30421011236132 ∅ ∅ 9 (4×)1022M3 (2×)9071,556,5 9 (4×)1022M3 (2×)9071,556,5 ∅ 6 pipe connections (×2) Cable feed-through Pneumatic locating station
XKPX 175 A
(A) = located, (B) = non-located. Note. Designed for use with chain XKTP5A. Chain XKTP5 cannot be used for XK pallet handling.Frame: cast aluminium. Rulers and guide pins: hard-ened steel. Locating accuracy: ±0,1mm. Maximum vertical force per ruler at 0,6MPa: 600N including pallet weight.The locating station should be installed on a separate support which is not rigidly connected to the
industrial conveyor beam.
Specify the locating station with guide rails with or with-out drip catcher.
Proximity switches are not supplied by FlexLink Sys-
tems. To indicate “pallet ready to lift”, a SICK proximity switch (IQ 10 series, sensing range 6 mm) or similar can be used. See figure below. Two
∅
12 holes are prepared in the locating station for additional proximity switches, to indi-
cate lifting of the pallet. 144
Pallet locating station