Text version of the page

Pallet stops – introduction

Principles of operation

Pneumatic pallet stops are used to stop pallets at selected positions along the line. Proximity sensors can be attached to the stop using bracket XBPB12H. An ini-tiator plate (5110904, page104) is attached to the front guide disc of the pallet. The stop is then mounted on the left side of the conveyor. The stop is double-acting, but also includes an inte-grated spring for stop out if air supply is cut off.It is possible to stop the pallet on the rear guide disc too, but in this case the pneumatic cylinder must be rotated 180°. The sensor bracket XBPB12H can be mounted directly to the side of the stop, or to the T-slot on the underside of the guide rail. XBPB 12 H XBPD 20×10

Pallet stops

Pneumatic pallet stop Bracket for horizontal proximity switch

4 2 60 50 75 M5 Bracket for horizontal proximity switchFor M12 sensors

XBPB 12 H

Sensors should have a sensing distance of 8mmScrew, washer and nut for the clamp part are included.Mounting to pallet stop XBPD 20×10: MC6S 5×12, BRB5,3×10Mounting to T-slot: MC6S 5×12, BRB5,3×10, XCAN5 Pneumatic pallet stop

XBPD 20×10

Including mounting hardware.

Accessories

Bracket for photo eye Reflector

∅ 6 23 15 2 5M18 2514 3 2 Bracket for photo eye

5059001

Mounting to T-slot in guide rail:M6S 6×30, BRB6,4×12, XCAN6 Reflector

5111135

Including mounting hardware. 116
Pallet stops – introduction