Definition of parameters (continued)
Motor type (MT) Queue stop (Q)
The motor unit can be mounted on the:•Left side of the conveyor•Right side of the conveyor•Below the conveyor (mid-mounted)Left/Right refers to the location of the motor in relation to the direction of chain travel. See figure. Queue stop is used for queue accumulation•Queue stop Q01•No queue stop Q00
This parameter determines if a non-shock absorbing or shock absorbing stopper is needed.•No damping of pallet, max. queue 200 kg (D00)•Max damping of pallet, max. queue 35 kg (D01)•Max damping of pallet, max. queue 100 kg (D02).
Function (F)
•Use of F depends on module. Currently used with support modules XTUF and modules XTUL P11 A and XTUL P12. LeftRight
Electric control (E) European /American motor (Hz)
Options: E00–E02•Without sensors•With PNP sensors•With NPN sensors Currently used with modules XTULP12 and XTURP11. See module descriptions for details. Operating frequency of the motor:•European, 50 Hz•American, 60 Hz.
General information
Support modules Minimum clearance distance
Note that the
conveyors, transfers and workstations are not delivered with support modules. They must be ordered separately (see page207). When two conveyors meet end to end, they must be sep-
arated by a minimum clearance distance. See the figure. The dimensions shown in the product drawings (L1/L”/...) include this clearance distance.
Standard or conductive
L 1 The conveyors, transfers and workstations can be deliv-ered in standard and conductive versions, see “Ordering information”. See also “Static electricity” on page203.
L 1 L, L 23 4,5 10 1010 Note on energy consumption
Since friction build-up is maximum in the bends, keep conveyor sections which are separated from the drive unit by bends as short as possible, to minimize energy consumption. XT CompactXT “standard”
Maximum load on conveyors
See “Chain tension calculations” software, and “Techni-
cal information” on page202.
Components and accessories
For detailed component information, see page221–245.
More information
For logic flowchart and pneumatic diagram: see separate document XT logic flowcharts . 200
General information