Group: FINETEK
Catalog excerpts
Ultrasonic Level Transmitter FineTek Innovation • Quality • Sharing
Open the catalog to page 1The ultrasonic level transmitter is a non-contact, low-cost and easy-to-install measuring device. It can be applied to most industrial applications for both solids and liquids. Most important aspect of is that it is easy-to-install and low maintenance due to no moving parts. WORKING PRINCIPLE During operation, the device emits a wave to the medium to be measured. The wave reflects off the surface and moves back to the device where a transducer calculates the distance. The distance is based on the time interval between transmission and reception of the wave. D= (334.1 +0.6t) x T/2, where the...
Open the catalog to page 21. Water or waste water treatment equipment: 3. Chemicals: paints, carbons, water, crude oil, pumps, open channels, dams and wells. epoxy resin, lime slurry and wax. 2. Edible-oils, sauces and beverages. 4. Diesel, Petrochemicals, alchohols, solvents etc. Liquid measurement Silo with rotational aiming kit
Open the catalog to page 32-wires (power supplied by panel meter) 0QO + +24V FineTek PB Meter The ultrasonic transducer is mounted to the flange of the extension nozzle of the tank. Please refer to the instruction below: Length for dead band: Dead band has to be 150mm over extension nozzle . Dead band needs to be set as 500mm if extension nozzle is shorter than 500mm. Extension length: Please refer to below table and choose the suitable probe
Open the catalog to page 5CAUTION BEFORE INSTALLATION Keep the transducer perpendicular to the liquid surface. The transducer should not be mounted too close to the tank wall to avoid interference. X A pipe surrounding the detection path along the ultrasonic wave from emitting to receiving is Recommended. Installation can prevent false signals caused by turbulence and foam when an agitator is present. When the pipe is installed, a vent hole is required to balance the pressure difference between the inside and outside of the pipe... Do not mount the device close to the tank wall. vent hole X Mount the transducer away...
Open the catalog to page 6Dimensions (Unit:mm) Ordering information
Open the catalog to page 7Taiwan onesia ■ Asia (<§ Taiwan FineTek Co., Ltd. - Taipei Head Quarter No.16, Tzuchiang St., Tucheng Industrial Park New Taipei City 236, Taiwan TEL: 886-2-2269-6789 FAX: 886-2-2268-6682 EMAIL: info@fine-tek.com ■ North America # California, U.S. Aplus Finetek Sensor Inc. - US Office 355 S. Lemon Ave, Suite D, Walnut, CA 91789 TEL: 1 909 598 2488 FAX: 1 909 598 3188 EMAIL: info@aplusfine.com ■ Europe <9> Germany FineTek GmbH - Germany Office Bei den Kampen 26 21220 Seevetal-Ramelsloh, Germany TEL: +49-(0)41 85-8083-1 2 FAX: +49-(0)41 85-8083-80 EMAIL: info@fine-tek.de ® China Fine...
Open the catalog to page 8All FineTek Co. catalogs and technical brochures
-
EFX By-Pass Level Transmitter
34 Pages
-
EPD Electromagnetic Flow Meter
28 Pages
-
Tuning Fork Level Switch
32 Pages
-
Ultrasonic Level Transmitter
8 Pages
-
Temperature Transmitter
5 Pages
-
Thermocouple
12 Pages
-
Vibrating point level switch
14 Pages
-
SA Capacitance Level Switch
18 Pages
-
SE Rotary Paddle Level Switch
15 Pages
-
EC Pressure Level Transmitter
12 Pages
-
SQ Pressure Switch
12 Pages
-
SD Optical Level Switch
2 Pages
-
FF Side Mounting Float Switch
15 Pages
-
FC/FD Mini Float Level Switch
28 Pages
-
RF-Admittance Level Switch
11 Pages
-
Optical Level Switch
13 Pages
-
Rotary Paddle Level Switch
15 Pages
-
Magnetic Float Level Transmitter
14 Pages
-
RF-Admittance Level Transmitter
15 Pages
-
Capacitance Level Switch
18 Pages
-
Vibrating Probe Level Switch
10 Pages
-
Pressure Level Transmitter
12 Pages
-
Magnetic Float Level Switch
24 Pages
-
EF By-Pass Level Transmitter
23 Pages
-
Air Hammer/Pneumatic Vibrator
16 Pages
-
Mini Float Level Switch
28 Pages
-
Pressure Switch
12 Pages
-
PID+Fuzzy Temperature Controller
23 Pages
-
Cable Float Level Switch
12 Pages
-
Side Mounting Float Switch
15 Pages