Catalogue - Pulse 1 Instruction Manual - Fast Heat - (Version JPG)

See other catalogues for Fast Heat

Nozzle, Cartridge heater, Coil heater, Strip heater, Thermostat

Text version of the page

GETTING STARTED

Pulse™ Series Control Instruction Manual

HEATER AND T/C MOLD CABLE(S)

QUICK REFERENCE

GETTING STARTED ................4

Unpacking Your Pulse ................4

What's Included..........................4

Pulse Cabinets............................5

Pulse Modules............................6

Heater & T/C Mold Cables..........8

Connecting AC Power................9

ABOUT..................................10

System Operation....................10

Pulse Screens............................12

Help ........................................14

Main Screen ............................15

Zone Setup Parameters............18

System Setup Screen................31

File System ..............................34

Security....................................35

Alarm......................................38

Printing....................................40

HOW TO................................41

Shutting OFF the Alarm............41

Setting Up Multiple Zones........41

Troubleshooting........................42

SPECIFICATIONS ..................43

General....................................43

System ....................................43

WARRANTY ..........................44

Connecting the Mold Cable(s)

Locate the new Pulse heater and thermocouple cables and attach the appropriate side to the Pulse control system (reference the connector diagram to the right).

T/C Connector {Zones 1-12) Heater Connector (Zones 1-12) T/C Connector (Zones 13-24) Heater Connector (Zones 13-24)

PLEASE NOTE:

Each cable end has a set of male and female connectors. Your system may contain a single cable that is specifically used for heaters, a single cable that is specifically used for thermocouples, and/or a cable that is a combination heater and thermocouple. Ensure that the correct cable is connected to the appropriate connector on the Pulse cabinet (reference the connector diagram below).

Mold / Junction Box Connector Pin-outs

HEATER CONNECTORS


ZONE	FAST HEAT	INDUSTRY STD.	DESIGNATION
1	1	A1	HOT
1	13	A2	RETURN
2	2	A3	HOT
2	14	A4	RETURN
3	3	A5	HOT
3	15	A6	RETURN
4	4	A7	HOT
4	16	A8	RETURN
5	5	B2	HOT
5	17	B3	RETURN
6	6	B4	HOT
6	18	B5	RETURN
7	7	B6	HOT
7	19	B7	RETURN
8	8	C1	HOT
8	20	C2	RETURN
9	9	C3	HOT
9	21	C4	RETURN
10	10	C5	HOT
10	22	C6	RETURN
11	11	C7	HOT
11	23	C8	RETURN
12	12	A9	HOT
12	24	C9	RETURN

REARVIEW HEATER CONNECTOR

m O m o m. o m. o m o m o m o m o m o m o

KO m o

o o

I I

ooo ooo ooo ooo ooo ooo ooo

OHp

OIO O

o o o

EEj E E ES E? ES

loioPlojo.

FAST HEAT (MALE)

INDUSTRY STANDARD (MALE)

Pulse 1 Instruction Manual - Fast Heat - #8

Nozzle, Cartridge heater, Coil heater, Strip heater, Thermostat