Precision LV Manifold Technical - Fast Heat - #14

The Precision LV Nozzle bodies are identical in design, but differ in length, diameter and head style. All Precision LV nozzles feature: unique sleeve heater design; Type "J" thermocouple; 36" teflon wrap - 600 Volt leads; right angle lead exit; and 6" fiberglass sleeving.

If the temperature controller does not utilize "soft start" technology, set the controller to 200°F (93.3°C) in automatic or 10% in manual. Allow bushing to "soak" for 15 minutes before increasing to processing temperature. This step will allow the unit to dissipate any moisture and prolong heater life.

1) Secure the bushing firmly using a "V" block on the diameter or a vise against the flats machined on the head of the bushing

2) Use standard 9/16", 3/4", or 1-1/8" socket and remove tip by turning counter-clockwise. Installation

1) Place bushing in "V" block and secure it firmly at the bushing head.

2) Apply anti-seize sparingly onto male threads of tip.

Note: Excess anti-seize may contaminate the resin being processed.

3) Use standard 9/16", 3/4", or 1-1/8" socket and install tip by turning clockwise.

4) Torque to 30 ft./lbs. (41 Newton-Meters)

• 240 Volts AC - 15 amp fuse

• Grounding - Fast Heat bushings utilize the direct contact of the bushing, mold plates, and machine platens to establish a path for grounding.

*WARNING* I

There must be a ground present between the Mold "Hot Half" and the temperature control system or damage may occur to the bushing, thermocouple and/or temperature control system.

International Manufacturing & Sales Offices: U.K. Tel: (44) 01323 647375 France Tel: (33) 4 77 49 36 46 Singapore Tel: (65) 398 0220

Hot Runner Systems by Fast Heat 1-877-RUNRHOT • (877-786-7468)

776 Oaklawn Avenue, Elmhurst, IL 60126 Ph: 1-630-833-5400 • Fax: 1-630-833-5414

L]4]

www.fastheat.com • email: hotrunner@fastheat.com

803 004 2.5M 903