| | | FAG heating device HEATER20 The FAG induction heating device HEATER20 for rolling manufacturer of bearings is suitable for bearings with bore diameters of 20 mm (with accessories 10 mm) and over and weighing up to 20 kg. This device can also be used to heat sealed and greased bearings and other. rotationally symmetrical steel parts. The heating device, complete with support ledges and magnetic temperature sensor, can be easily transported in a practical protective carry case. It is particularly suitable for mobile mounting assignments. | | |
| | | The two lateral supports carry the support ledge. The part to be heated can either be placed on the round surface over the induction coil or placed around one of the three support ledges. The contact surfaces of the support ledges and the stands are ground so that loss of power remains low. The heating device can be connected to any standard two-pin safety socket which is protected by a 16 A fuse. The clearly structured control panel can also be operated while wearing work gloves. The touch keyboard is oil-resistant, dustproof and waterproof. | | All functions can be controlled by means of three keys (two to set the temperature and one to start and stop the device). The device offers a temperature control mode (see page 5). | | |