Catalogue - F.CN13.130 - N.C. Operating units - EUROMA



N.C. opemting units

F.CN13.130

Drilling Tapping capacity capacity

mm					mm

	F.CN13.130
		130 10 14 M12 M16 1500 20 7035 GAS 0.01

Numerically controlled programmable unit. • Suitable for: drilling, tapping (in the standard configuration, compensating spindle is recommended), reaming and spot facing. • Spindle drive = Three phase asynchronous motor and toothed belt. • Quill feed = rolled, precision 16 mm dia. x5mm pitch ball screw, pre-loaded to "0" back lash. Toothed belt drive = 1:1 (or otherwise) ratio, and brushless motor mounting (not supplied, but to be specified) provision • Quill position limit switches = n°1 forward, n°1 at rest, n°1 "0" point. Unit must be orclerecl complète with one of the following output spinales: B12TaperDIN 238 = AT 1 Code28010012 ER20Colletholder(cap.1-13) = AT3 Code28010016 16mm.dia.straightboreDIN 55058 = AT4 Code28010020 N°1Morsetaper = AT5Code28010024

10

287								140
22							0
53			7 CO			11
			2 7 S)
68
			J 0 30		218
(33
30				236		75	514
				855

(33

52

F.CN13.130 - N.C. Operating units - EUROMA - #1