QSet™ - ESAB - #1

Text version of the page

QSet™ - Stable short arc in no time QSet™ is a built-in function in the MA23A panel which provide an unique way of setting welding parameters in short Arc. Simply set the wire feed speed and the QSet™ will automatically select the correct welding parameters for the required wire/gas combination. QSet™ does this for all valid gas and wire combinations, CO2 and MIG Brazing alike and without any need of synergic lines. QSet™ is a new quick way to obtain optimised welding parameters for the best quality weld. Spatter is reduced to a minimum. XA00127620 ESAB AB Herkulesgatan 72, Box 8004 SE-402 77 GÖTEBORG SWEDEN Phone: +46 31 50 90 00 Fax +46 31 22 04 49 E-mail: info@esab.se www.esab.com 2006-03-26 ESAB reserves the right to alter specifications without prior notice ESAB is approved according to ISO 9001:2000 Customer benefits • No need for synergic lines • Constant Arc • Constant Arc • One knob control • One knob control • One knob control (remote) • One knob control • One knob control • Increased stability of Arc • Increased stability of Arc • MIG brazing • Welding with CO2 gas • Change gas and wire type without any need of changing setting on the machine. • Good adaptation to changes in contact tip distance • Constant penetration during welding. • Simple setting- Set only wire feed speed and all other parameters automatic set by control system. • Easy to find optimised “welding parameter” application data. • Easy to change parameters during welding and keep the optimised welding parameter. • Faster set-up time (only need to set wire feed speed). • It is still possible to modify heat and arc length by the voltage trim. • Less spatter gives minimised after treatment work. • Easier to use in in the globular area - less spatter. • Alternative to pulsed welding and minimised spatter with a low heat input. • Easy to find optimised “welding parameters” application data. enables the best CO2 characteristic. MMC funtions • CC/CV • Digital meter • 3 memories • 2-4 stoke • Inductance setting • Manuel Gas purge and wire feeding • Remote control • QSet™ • Spotwelding It is simple and straightforward to set a new working point with QSet™. Only change wire feed speed to match the required welding power and then QSet™ will select all other parameters for an optimised welding result in the whole short arc area. QSet™ will be the welders best help to quickly and with the best quality set new welding parameters with a one knob setting. The first start with a new wire type with a matching gas type QSet™ will learn to set all necessary parameters. After this first start QSet™ will remember the data to make good starts. QSet™ can also run in spray arc area, with an increased voltage trim setting. To weld with pure spray arc it is just to disconnect the QSet™. All settings are inherited from the QSet™ except for the voltage setting which must be adjusted. Applications Origo™ Mig C3000i, MA23A Origo™ Mig L3000i and Origo™ Feed L3004, MA23A