Text version of the page

Pressingpowder

Pressed-powder parts are become more and more refined.The special shapes are manufactured in small batch sizes. Powder presses have to be reset frequently. EROWA‘s PM Tooling cuts resetting time to less than 2 minutes! It‘s plain to see: if resetting times must be reduced, a tooling system will have to be used. The EROWA PM Tooling was specifically designed for use under high pressure. The upper and lower punches as well as the die-plates are machined on the PM Tooling, right from the start until they are used in the press. Thanks to the system‘s positioning accuracy and stability, all the punches and die-plates produced on the system can be changed in the twinkling of an eye.
Upper punch on EROWA PM Tooling palletPositioning accuracy