Text version of the page

®

Rotary and Contra-Angle Handpieces

For Use with Electric Motors with Flexible Shaft

Model 30 Handpiece Model 35 High Speed Handpiece

The Model 35 Handpiece, when used with Di-Profiler motors, will provide speeds up to 35,000 RPM. The safety torque control and low noise level makes operation fast and easy. The tool is especially efficient when used with high speed diamond burrs, points and wheels. The tool comes equipped with a 1/8" collet.Additional collets for use with the Model 35 Handpiece are: The Model 30 Handpiece has a key-type chuck with a chuck capacityfrom 0 to 5/32". Grease sealed ball bearings provide long, trouble- free operations. Chuck Key No. 72 (not shown).

SizePart No. 1/8”103114 3/32"103115 2.35mm103117

Model 44 Handpiece

Part No.CapacityRange 4411/16".050 to .0624423/32".085 to .0934431/8".113 to .1254445/32".144 to .156 4453/16".177 to .1874467/32".208 to .2184471/4".238 to .250 Set No. 440 Set of 7 collets(441-447) with holder

Model 55AHandpiece

The Model 55ARight Angle Handpiece has a chuck capacity of 3/32".Overall length of this handpiece is 6-1/4", largest diameter 5/8". The Head is permanently set at a 30" angle. Note: Use only with wheels and points that have short type "R" slotted shanks. This tool is equipped with a 1/4" collet for use with rotary tools having1/4" shanks.Additional collets for use with the Model 44 Hand Piece are:

105 W. Hintz Road ? Wheeling, IL60090-6038Toll Free: 1-800-99-ENGIS (1-800-993-6447) E-mail: info@engis.com

www.engis.com

Mold Polishing Supplies - 26511 1-4