Puller Section Overview

Puller FunctionCapacity Puller TypeSeries PageWhen selecting a puller it isimportant to consider 3basic specifications: 1. The Capacity: ton

8-50

Master Puller Sets

BHP 152

Max. Reach:252 - 700 mmMax. Spread:250 - 1100 mm is the amount of force thepuller is capable ofproducing. Typically, the capacity required for a ob can be determined by using the shaft diameter of the partbeing pulled.For manual pullers, the center bolt diameter of the puller should be at least half the diameter of the shaftbeing pulled from.For hydraulic pullers, the capacity in tons should be 0,28 to 0,4 times the shaft diameter in mm. Use thefollowing chart:

8-508-50 8-50 8-50 2-40 10-50

Grip Puller Sets

BHP BHP BHP BHP EPEPP EPX 153154 155 155 156 160

Max. Reach:249 - 700 mmMax. Spread:50 - 580 mm

Cross Bearing PullerSets

Max. Reach:354 - 863 mmMax. Spread:266 - 570 mm

B

Bearing Cup Pullers

ShaftPuller Max. Reach:110 - 145 mmMax. Spread:26 - 359 mm
DiameterCapacity 0 - 25 mm10 ton 25 - 50 mm20 ton 50 - 89 mm30 ton 89 - 140 mm50 ton

Bearing pullers

2. The Reach: Max. Width:110 - 264 mm Max. Spread:10 - 245 mm is the distance between thebottom of the base and theaw flats. The pullers reachmust equal or exceed thesame distance of the part being pulled. 3. The Spread:

Posi LockMechanicalPullers

is the distance between theaws. The pullers spreadneeds to be greater than the width of the part being pulled. Max. Reach:101 - 355 mmMax. Spread:12 - 635 mm

EPPMI

Posi LockHydraulicPullers

EPH EPHR EPHS

Max. Reach:203 - 355 mmMax. Spread:304 - 635 mm

100

Posi LockHydraulicPullers

EPH 163

Max. Reach:1219 mmMax. Spread:190 - 1778 mm

www.enerpac.com

11