Shockproof Load Cells - Eilersen Electric - #1

Industrial Sensors

• Stainless steel

• Robust capacitive technology

• High tolerance of up to 1.000 % overload

• Hermetically sealed to IP68

• High accuracy, High resolution

• Digital filters

• Cable length up to 100 meters

• Calibration independent ofcable length

• Load cell cable replaceable

• Easy mechanical and electrical installation

• Withstands welding voltages and ESD

• ATEX certified

• 3 years warranty

The shockproof digital load cell is based on a capacitive measurement principle where a non-contacting ceramic sensor is mounted inside the load cell body. As the load cell contains no moving parts and the sensor is not in contact with the load cell body, the load cell tolerates shocks, torsion, and very high overloads and sideloads. Therefore, the mechanical installation ofthe load cell can be done without expensive and complicated mounting kits and overload protection devices.

The electrical installation of the digital load cell is pure plug-and-play as the signal from the non-contacting sensor is directly converted, compensated and calibrated by a microprocessor to a digital load cell output in grams, kilograms, or Newton. Measurements and status codes are transmitted as RS485 data on a single wire coaxial cable (RG-58) which may be up to 100 meters long. The load cell cable can be replaced on-site if necessary.

The technology and mechanical design of the Eilersen load cells is covered worldwide by a number of patents.

• 5 • ATEX (Zone 1, 2, 21, 22) version • Dynamic weighing

• 10 type BBLA • Process weighing

•20 • ATEX H2GEx ia IIC T6 • Filling, batching, sorting and

•30 • ATEX II 2D Ex iaD 21 T85°C dosingequipment

• 50 • Mounting kit available • Vibration sorters

• 100 • Packaging machines

• 150 • Hopper scales •250 'Beltscales

• 500 • Conveyer scales

• 1.000 • Platform scales

• Big-bag equipment

• On-board vehicle weighing

Version 1/08