RadiControl® - 2 Pages

To enable full EMC Site Automation D.A.R.E!! Development introduced a
broad range of products. These products provide a complete solution to
automate antenna measurements at multi height and EMC measurements at
different EUT angles.
RadiControl®
RadiControl® is a universal versatile controller that provides full control over
virtual any brand of antenna tower and/or turntable. Next to this the controller
supports frequency inverters, potential-free contacts (up/down & on/off), 12V
signals and/or a RS232 bus (standard). Optionally the controller can be
equipped with an USB interface or IEEE 488 bus. The controller can be used
manually or by of D.A.R.E!! Development software package RadiMation®, thus
realizing fully automated EMC tests.
RadiTurn®
RadiTurn® is a low profile RF transparent surface mounted turntable. In many
applications it is difficult to build-in a turntable. This is especially true for Open
Area Test Sites and Anechoic chambers. Not only the space beneath the floor is
limited or absent, but also the electrical connection of the turntable with the
surrounding floor often leads to great disturbance problems and high
maintenance costs. This is why D.A.R.E!! Development has designed a low
profile RF transparent turntable. With a height of less than 80 mm and no
reflective planes, this table is excellent for use in both new and existing EMC
test environments. This combined with a maximum load capacity of 10.000 kg
and a point load capacity of 250 kg, makes this a highly unique product.
RadiTower®
RadiTower® is a robust antenna tower for EMC use. The tower is completely
RF transparent because of use off polycarbonate/PVC, and is weather proof and
non hygroscopic. This is an excellent solution for use on an Open Area Test Site
or antenna calibration site. The engine can be mounted next or under the tower,
depending on the specific site situation. The position of the antenna is measured
by means of an absolute encoder on the engine. This delivers a standard
accuracy of approximately 10mm. For extended use of antenna calibrations, a
high precision sensor can be mounted to the centre of the antenna, thus
obtaining an increased height accuracy of 1 mm. A software protection is
implemented that controls the upper- and lower limit, motor direction and
motion detector.
Emc Site Automation
Dijkstra Advies, Research & EMC Electronics B.V.
Vijzelmolenlaan 7 – NL-3447 GX Woerden
The Netherlands
Tel: +31(0)348 48 11 44
Fax: +31 (0348) 48 06 52
Internet: www.dare.nl
E-mail: info@dare.nl
The Standard for Consultancy, (Re)design
and Training in EMC and Product Safety
DARE!!
Development

RadiControl®
  1. P. 1

  2. P. 2

    Technical SpecificationsRadiControl® Universal ControllerPerformanceControl : Manual and/or software controllableRange : 1 – 6 m (tower), 360...
Text version

All DARE!! Instruments catalogues and technical brochures

  1. RadiPower®

    2 Pages

    En
  2. RadiCentre®

    2 Pages

    En
  3. RadiSwitch®

    2 Pages

    En
  4. RadiLink®

    2 Pages

    En
  5. RadiMate®

    2 Pages

    En
  6. RadiMation®

    2 Pages

    En
  7. RadiSense®

    2 Pages

    En