SterimasterTM CHAMBER/LOAD SENSOR ASSEMBLY The environmental conditions found in pharmaceutical autoclave chambers are extreme for any equipment. These conditions are a major cause of sensor failure in chamber/load probes, due to the ingress of moisture into the sensor and the unacceptable leakage of steam/condensate through the bulkhead connection. The SterimasterTM Chamber/Load Sensor has been designed to withstand these conditions and offers a reliability factor surpassing anything previously obtainable. Every weld undergoes NDT examination and each completed assembly is leak tested. SPECIFICATIONS Mechanical Sensor Diameter · 3.0 mm, 3.18 mm (0.125 ), 4.76 mm (0.187 ), 6.0 mm, 6.35 mm (0.250 ) Sensor Length · 100 mm (4 ) minimum, 305 mm (12 ) maximum · 316 stainless steel Flexible Armor · 10.6 mm (0.42 ) OD x 9150 mm (30´) maximum · 316 stainless steel Bulkhead Tailpiece · 6.0 mm, 6.35 mm (0.250 ) OD x 152 mm (6 ) long standard · 316 stainless steel Leadwire/Jacket Length · 6100 mm (20´) maximum RTD Element Single or dual PT 100 with 3- or 4-wire connection, Class "B" and "A" tolerance meeting BS EN 60751:1996. Fractional 1/10 tolerance available. Leadwire/Jacket PTFE insulated 26 AWG stranded conductors with thick-walled extruded silicone rubber jacket Operating Range · -50° C to +150° C (-58° F to +302° F) · Vacuum to 3.5 bar (50 psig) Thermocouple Type Single or dual types "T", "E", "J" or "K" to ASTM E230 Leadwire/Jacket PTFE insulated 26 AWG stranded conductors with thick-walled extruded silicone rubber jacket Operating Range · -50° C to +150° C (-58° F to +302° F) · Vacuum to 3.5 bar (50 psig) Sterimaster shown with optional sanitary flange mount. Model SL104 is used for water cascading and steam sterilizers. Note: Multiple detector configurations are determined by the sensor diameter. Accessories Various types of tailpiece sealing gland assemblies are available. Refer to Conax Buffalo Technologies' Pressure and Vacuum Sealing Assemblies, Catalog 5001A.