Magneta Miniature Clutches - Bearing Mounted - Clutch Parts - #1

Type 14.i00.H.iil 0.6 to 3.6 Nm

New design with 50% torque increase Speed up to 10,000 r/min Bores 5 to 15mm

Stationary field and maintenance-free Without backlash No running-in required Very fast operating times

Clutches type 14.100.^1.1.1 comprise three parts, the stator, the rotor and the armature of design 1 or 3. The assembly is axially compact and suits high speed running but see also bearing mounted clutches 14.100.^1.3 which are simpler to install.

Select armature type 1 for in-line shaft to shaft drives but observe the necessary shaft alignment limit tw.

Armature type 3 is designed to be mounted onto pulleys, gears or sprockets which must in turn be bearing supported from the shaft.

The coil is supplied with D.C. voltage generating a magnetic field which passes through air gaps to the rotor and then pulls in the armature plate. Armature movement is achieved by the backlash-free spring. If the current supply is interrupted the magnetic field collapses and the spring pulls back the armature plate leaving no residual torque.

(6) off clutches type 14.100.05.113 24V, 10mm bore