In a manually operated system, the probingforce ranges between false contacts and too heavily applied measuring forces. Both extremesfalsify results. Therefore, ScanMax

automatical-ly monitors the force which the operator applies during the scanning process. And it records onlythe points which were captured with the rightmeasuring force. This means that operator influences are eliminated, which is important when the systemis used by several different operators. Just trace the workpiece contour, and the systemautomatically computes the required workpiece alignment.

Measuring with ScanMax
® Defining reference points withScanMax

No matter whether you want to scan boreholes, grooves, steps, surfaces, forms or free-form elements with interruptions, ScanMaxautomatically identifies the measuring task and supplies the results you need.

Software alignment is a relatively complexprocedure in most systems. Not for ScanMax.

In the signal light mode,the summarizedresult is available at a glance. Rapid measurement ofdimension,formand position directly in the productionarea saves time and provides detailedinformation on the current manufac- turing process. A picture says more ....After scanning,take a look at the graphicillustration ofthe workpiece.In the signallight mode,the summarized result is available at one a glance – OK or NG (No Go). Rapid measurement ofdimension,formand position directly in the productionarea saves time and provides detailedinformation on the current manufactu- ring process. 9 Reliable ScanMax

(Screenshot)