Group: Bucher
Catalog excerpts
Proportional Pressure-Relief Cartridge Valve, Size 1 Qmax = 1.5 l/min, pmax = 420 bar Pilot valve, seated design, direct acting Series DVSA-1L... • Can be used as a pilot valve • Compact construction for cavity type AL - 3/4-16 UNF • Operated by a proportional solenoid • In a power failure, the pressure setting drops to the minimum value • 5 pressure ranges available • All exposed parts with zinc-nickel plating • High pressure wet-armature solenoids • The slip-on coil can be rotated, and it can be replaced without opening the hydraulic envelope • Various plug-connector systems and voltages are available • Can be fitted in a line-mounting body 1 Description These proportional pressure-relief cartridges, series DVSA-1L..., are size 1 pilot valves featuring a seat-valve design and a 3/4-16 UNF mounting thread. With these pressure-relief cartridges, the relief pressure is dependent on the electrical control signal and can be continuously varied. When the solenoid is de-energised (initial position), connection 2 ^ 1 is open and the minimum pressure (free flow) depends on the flow rate. Any pressure at port 1 is additive to the valve setting at port 2, therefore port 1 should preferably be connected directly to tank. In control mode, the relief pressure is proportional to the change in the required value (amplifier output current). In order to obtain precise pressure settings over the whole of the required pressure range 2 Symbol (optimum resolution), the pressure relief cartridges are available in five pressure levels. These proportional pressure-relief cartridges are primarily used as pilot valves, mainly in mobile and industrial applications to allow a pressure in hydraulic installations to be limited electro-propor-tionally. All external parts of the cartridge are zinc-nickel plated to DIN 50 979 and are thus suitable for use in the harshest operating environments. The slip-on coils can be replaced without opening the hydraulic envelope and can be positioned at any angle through 360°. If you intend to manufacture your own cavities or are designing a line-mounting installation, please refer to the section “Related data sheets”.
Open the catalog to page 1Performance graphs measured with oil viscosity 33 mm2/s (cSt) p = f (I) Pressure-adjustment characteristic (at Q = 0.3 l/min) p = f (I) Pressure-adjustment characteristic (at Q = 0.3 l/min) Pressure v. Flow rate characteristic pN = 40 bar Pressure v. Flow rate characteristic pN = 100 bar Pressure v. Flow rate characteristic pN = 160 bar Pressure v. Flow rate characteristic pN = 250 bar Pressure v. Flow rate characteristic pN = 350 bar
Open the catalog to page 3|0j= IMPORTANT! To achieve the proportional pressure-relief cartridge's maximum performance rating, fit the solenoid coil as shown (with the plug pins at the bottom). When fitting the cartridges, note the mounting attitude (preferably vertical, with coil down ^ automatic air bleed) and use the specified tightening torque. No adjustments are necessary, since the cartridges are set in the factory. ATTENTION! To prevent any pressure surges, port 1 must be routed to tank with the least possible back-pressure. Any tank pressure acting at port 1 is additive to the pressure setting at the main...
Open the catalog to page 4pressure-relief cartridge, pilot valve standard solenoid (proportional) standard model - see relevant data sheets special features - please consult BUCHER pressure function 1 (pressure-relief) cavity type AL pressure range ...350 bar pressure range .250 bar pressure range .160 bar pressure range .100 bar pressure range . 40 bar nominal size 1 (primarily for pilot controls) NBR (Nitrile) seals (standard) FKM (Viton) seals (special seals - please contact BUCHER) design stage (omit when ordering new units) voltage e.g. 24 (24 V) current DC ISO 4400 / DIN 43 650 mating plug (standard, IP 65)...
Open the catalog to page 5All BUCHER Hydraulics catalogs and technical brochures
-
APM212HP
56 Pages
-
APM212
56 Pages
-
QXM42-HS
8 Pages
-
QXM-Mobil
8 Pages
-
AP312-HP
46 Pages
-
AP250-HP
46 Pages
-
AP212-HP
56 Pages
-
AP300
22 Pages
-
AP212
60 Pages
-
AP100
28 Pages
-
AP05
26 Pages
-
Qx series
36 Pages
-
QXV series
8 Pages
-
QXP
8 Pages
-
QXM series
16 Pages
-
QXEM
12 Pages
-
DVs series
5 Pages
-
DWPB
7 Pages
-
QXEH series
12 Pages
-
Hydraulic Elevator Drives
4 Pages
-
SDDA ... S
4 Pages
-
QX3
32 Pages
-
Pressure Unloading Valve
7 Pages
-
Cartridge Valves
2 Pages
-
QXT series
8 Pages
-
DVS series
5 Pages
-
DWP
6 Pages
-
APM series
56 Pages
-
AP series
26 Pages
-
BH_Imageflyer_EN_2011
18 Pages
-
High Pressure Flow Divider
5 Pages
-
Flow Divider Series MTDA
4 Pages
-
Load Control Valves
164 Pages
-
Hydraulic Units UP 100
144 Pages
-
Internal Gear Pump
32 Pages
-
Hydraulic Units UP 110
24 Pages
-
Hydraulic Units UP 50
38 Pages
-
D.C. Electro-pumps, series ET
32 Pages
Archived catalogs
-
Check valves, size 06 ... 20
4 Pages
-
External gear pumps, series AP
96 Pages