Catalogue Type-FPM Controls with Analog Interface Boards
www.bodine-electric.com
print switch display
Page / 37
Contact the
Manufacturer
Where to buy
this product ?
Request
a Quote
BODINE ELECTRIC - 2505
/ 37
See other catalogues for BODINE ELECTRIC
Text version of the page
SAFETY PRECAUTIONS
The following safety precautions must be observed during all phases of opera­tion, service, and repair of this electronic drive/motor product. Failure to comply with these precautions or with specific warnings elsewhere in this manual violates safety standards of design, manufacture and intended use of the products. Bodine Electric Company assumes no liability for the customer's failure to comply with safety requirements and practices.
Warnings, such as the example betow, highlight potentially dangerous proce­dures throughout this manual. Instructions contained in the warnings must be followed.
WARNING
Dangerous voltages capable of causing death may be present in the electronic control and motor. Use extreme caution when handling, testing, and adjusting. Properly guard the electronic control and motor to prevent accidental contact by both knowledgeable and unknowledgeable persons.
"The use of electric motors and generators, like that of all other utilization of concentrated power, is potentially hazardous. The degree of hazard can be greatly reduced by proper design, selection, installation, and use, but hazards cannot be completely eliminated. The reduction of hazard is the joint responsi­bility of the user, the manufacturer of the driven or driving equipment, and the manufacturer of the control or motor or generator." *
Bodine products are designed and manufactured to comply to applicable safety standards and in particular to those issued by ANSI (American National Stan­dards Institute), NEMA (National Electrical Manufacturers Association), U.L. (Underwriters Laboratories, Inc.), and CSA (Canadian Standards Association).
* Standards Publication No. ANSI C5.1/NEMA MG-2. "Safety Standard for Construction and Guide for Selection, Installation and Use of Electric Motors and Generators."
Available from:
National Electrical Manufacturers Association 2101 L Street N.W. Washington, D.C. 20037, U.S.A.
6
DirectIndustry's Virtual Technical Library: PDF Catalogue | Technical Documentation | Brochure | Manual | Industrial directory | Specifications | Characteristics
Search Go
page 1 p.1
page 2 p.2
page 3 p.3
page 4 p.4
page 5 p.5
page 6 p.6
page 7 p.7
page 8 p.8
page 9 p.9
page 10 p.10
page 11 p.11
page 12 p.12
page 13 p.13
page 14 p.14
page 15 p.15
page 16 p.16
page 17 p.17
page 18 p.18
page 19 p.19
page 20 p.20
page 21 p.21
page 22 p.22
page 23 p.23
page 24 p.24
page 25 p.25
page 26 p.26
page 27 p.27
page 28 p.28
page 29 p.29
page 30 p.30
page 31 p.31
page 32 p.32
page 33 p.33
page 34 p.34
page 35 p.35
page 36 p.36
page 37 p.37
pdf-page pdf di En 2009-01-02-09