| 1. Decide whether you will control speed by inputting a variable voltage or current signaltoTB2-6orTB2-7 (Fig. 5), and whetheryou will use an optional electronic Forward-Brake-Reverse (F-B-R) Board to control the direction of rotation. 2. Locate connector J5 on the Analog Interface Board shown in Fig. 4. 3. To select current or voltage inputs and reversing or no reversing, attach the push-on plastic cap jumpers provided with your FPM control to J5 as shown In Fig. 6 and as described below. A. To use current inputs, place a jumper across terminals 1 and 2 of socket J5, and place a second jumper across terminals 5 and 6 of J5. B. To use voltage inputs without reversing (without the Model 890 Electronic F-B-R Board), place a jumper across terminals 3 and 4 of J5. C. To use voltage inputs with reversing (with the Model 890 Electronic F-B-R Board), place a jumper across terminals 1 and 2 of J5. Note: An additional jumper is available on J4 connector at pin 1 and 2. |