CONNECTION

CAUTION

The PCB inside the control enclosure is vulnerable to static electrical charges. Avoid contact with the PCB. Choose an appropriate power source with correct voltage settings for the specification of the control. Do not use a separate device between control and motor to switch motor ON or OFF during operation.

Step 4 – Preliminary Setup

Figure 4 - Inside layout of control. AC LINE VOLTAGE SELECTOR SWITCH – If the control is to be operated from a 230 VAC power supply, slide the selector switch from “115V” to “230V.” AC LINE VOLTAGE JUMPER – If the control is to be operated from a two-phase 230 VAC power supply, where both lines are hot (typically in the USA), then remove the jumper wire between the spades labeled “BYPS1” and “BYPS2.”

8