PRODUCT SPECIFICATIONS

ABOUT THIS PRODUCT - Bodine’s Model 1865 is designed to provide variable speed control of standard Permanent Magnet Dc motors. Adjustable acceleration and deceleration are provided, making the drive suitable for soft start applications. The full-featured drive is easy to install and operate. Simple trim pot adjustments eliminate the computer-like programming required on other drives. However, for most applications, no adjustments are necessary.

Table 1 – Electrical Ratings Input Volts 115 or 230 VAC +/- 10%, Single Phase, 50/60Hz Max. Continuous Input Current 3.4 Amps RMS Output Volts 0 to 90 VDC or 0 to 180 VDC Max. Continuous Output Current 2.1 Amps DC Max. Peak Output Current 5.1 Amps DC Max. Form Factor 1.6 Maximum Motor HP 1/5 HP @ 90V 1/3 HP @ 180V Table 2 - General Performance Specifications Parameter Specification Factory Setting Speed Signal Input Voltage 0 – 5 VDC (must be isolated from AC line) N/A (speed pot) Minimum Speed Trim Pot Range 0 – 50 VDC output to motor with input speed signal set at 0 VDC 0 VDC (full CCW) Maximum Speed Trim Pot Range 60 – 100% of full motor speed with input speed signal set at 5 VDC 100% Acceleration Trim Pot Range .2 – 10 seconds to ramp output voltage up from 0 to 90 VDC and .2 – 20 seconds to ramp up from 0 to 180 VDC 2 sec. (0-90V) 4 sec. (0-180V) Deceleration Trim Pot Range .2 – 10 seconds to ramp output voltage down from 90 to 0 VDC and .2 – 20 seconds to ramp down from 180 to 0 VDC 2 sec. (90-0V) 4 sec. (180-0V) Peak Current Limit Trim Pot Range 0 to 200 – 250% of motor nameplate rating with appropriate dip switch settings 200 – 250% (full CW) Speed regulation (Change in motor speed from no load to full load) Less than 2% of Rated Speed with most motors and less than 1% with many 1 – 2% Operating Temperature Range 0 to +40
O C N/A

4