INSTALLATION INSTRUCTIONS

WARNING
This control should only be installed by a qualified technician, electrician orelectrical maintenance person familiar with its operation and associatedhazards. The National Electrical Code (NEC), local electrical and safetycodes, and when applicable, the Occupational Safety and Health Act(OSHA) should be observed to reduce hazards to personnel and property.The user must provide a proper enclosure for chassis type controls.Circuitry is not at ground potential. Do not perform work on or near thecontrol while it is connected to the AC line. CAUTION
Exposed circuit boards should be protected from electrostatic discharge.The control board uses CMOS circuitry. Static discharge into the controlboard must be avoided to prevent component damage. Mounting the Control The mounting template (provided in the center of this manual) can be used toposition and mark the location of mounting holes on the surface where the control is to be located. The control should be mounted vertically, using the slots on either the narrow or wide surfaces of the heatsink. This arrangementprovides optimum air flow around the control. Refer to Figure 2. Electrical connections Read the following instructions as well as all of the applicable safety recommen-dations, before making any electrical connections between the control, motor, or motion control electronics. WARNING
The 115 VAC power line to the control should be the very last connectionmade. Disconnect the power line before making any other electricalconnections. 10