Pipe measuring points + Sensors for Hydraulic Systems

Bolender Maschinenkonstruktion

„LEAKAGE AND SEALING DAMAGE DETECTION SENSORS FOR HYDRAULIC SYSTEMS“ LS-2-B-… Leakage Sensor fluid-Check ® Almost up to the last drop Rolling mills include numerous hydraulic pipes installed in ducts or within the rolling stand. Even small quantities of hydraulic oil leaking from pipe systems, tubes, valves or cylinders can cause enormous costs. The disposal of contaminated rolling oil or rolling emulsions is expensive. Cleaning and refilling involve downtimes, resulting in reduced system availability. To avoid these problems, BKM developed the leakage sensor LS-2-B-… fluid-Check ® . LS-2-B-… easily detects and immediately reports leakages as small as 0.005 liters/minute. As the leakage is indicated in liters/minute, you can immediately decide whether 1. the system must be shut down immediately to remove the leakage or 2. the problem does not require immediate action and can be addressed during planned downtimes. In any case, LS-2-B-...-3/8“ allows you to make the right decision. How is this possible? The leakage sensor LS-2-B-...-3/8“ fluid-Check ® is supplied together with BKM 's pipe measuring connector serv-Clip ® for the corresponding pipe diameter. LS-2-B-...-3/8“ measuring system as no moving parts are placed in the oil stream. Another major advantage of the system is that the leakage sensor can be installed within a few minutes as it is not necessary to cut pipes. The pre-set flow rate for the normal operation of the cylinder or oil motor is not affected. Even on the long run, the increased oil quantities involved in the normal operation of hydraulic systems do not cause damage to the How accurately does the system measure? It is advisable to install the system on pipes with an outer diameter of 12 to 38 mm. It is also possible to carry out measurements with larger pipe diameters; in the lower measurement range, measurements begin with 0.05 liters/minute (it depends on the pipe diameter) For special measuring tasks, including high measurement ranges, it is possible to set values of up to several 100 liters per minute.
Bolender Tel. (0 23 31) 30 63 9 – 16 Service-Tel. 0700 BKM HAGEN Geschäftsführer: Maschinenkonstruktion GmbH Fax (0 23 31) 30 63 9 – 11 Service-Fax 0700 SERV CLIP Klaus Bolender Sedanstr. 41 http://www.servclip.de sales@servclip.de HRB-Nr. 1878 D-58089 Hagen http://www.BKM-Hagen.de SKYPE MSN servclip MEZ 08:30-16:30 UST-ID-Nr. DE 125 137 184