HDS2 - Bishop-Wisecarver - (Version JPG) - Page n° 19 - PDF Catalogue | Technical Documentation

See other catalogues for Bishop-Wisecarver

Slide, Roller guide, Profile, Telescopic slide, Linear guide

Text version of the page

Ba<k Plat»

Mounting surfaces and location facet are manufactured to precision extrusion tolerances and are adequate lor most applications Back plates are manufactured from high strength aluminum and are supplied clear ancdized. Compatibility of back plates with the various sizes and types of slide, tracks, bearings and lubricators can be found on 46 & 47

Alignment procedure

It is normaf to use one adjustable slide/ track and back plate element in conjunction with one non-adjustable element. The non-adjustable element should be located onto a key_r dowel pins, or otherwise set adequately straight for the application and bolted down tight.

Where the construction beams are used, the non-adjustable element should be located by means of location T-nuts types T and the adjustable element by means of the alignment T-nuts type W. [for T-nut details ^13%).

For applications not requiring a construction beam, the adjustable element should be located onto a reduced width key section or dowel pins type SDPA midway between hole centers. The hole in the mounting surface for fixing should be spotted and drilled from the back plate to ensure even clearance around the screws.

The adjustable element should be set parallel to the non-adjustable element at the end hole positions, with the jacking screws set For even clearance around the fixing screws, and the end screws tightened down. Working outward from the center of the element and with all but the end screws fully retracted, each jacking screw should be progressively jacked in to influence the elements parallel with the corresponding position on the opposing element, then both jacking screws locked and the corresponding fixing screw tightened down. Depending upon available hole clearances, it is possible to bend an element up to 1mm pro-rata per meter.

Alignment principle for use with beam Hole configuration 'B^f ~²

Low Wide Baili Plate

—J—

1 1

HLW25

3Qm.il

4J1I-«.

General alignment principle Hole configuration A' *²

HHW25 High Wide Back Plal«

Fig 2,

Dowel Pin';


Part Number	OAS	H	0C3	D	E
SD PS	8	8		2.75	-
SDP12	12	15	10	3.75	-
SDPU	14	15	12	3.75	-
SDP15	15	15	10	4.75	-
SDPló	16	15	12	3.75	-
SDPA14	14	20	10	75	10
SDPA1Ó	16	20	12	75	12

"hi"

SDPA

Stainless steel with SS. Exam

SDP

dowel pins are available, prefix the part number ple-SSSDP3

Ordering Example for Back Plates HLN 25

Part number -

L1886

C43

D4¿

Alignment type Aar B'⁵Lsaw blcmk if not required

V slide or flat track size ■ Overall length-

C &. D dimensions*¹

HDS2 - Bishop-Wisecarver - #19

Slide, Roller guide, Profile, Telescopic slide, Linear guide