T18U Series

U-GAGE

®

Sensors

T18U Specifications (cont’d) T18U Specifications

Output Response TimeNORMAL resolution mode: 2 milliseconds ON and OFF HIGH resolution mode: 1 millisecond ON and OFF Rep RateNORMAL resolution mode: 125 Hz max. HIGH resolution mode: 200 Hz max. Mechanical Sensing Repeatability at 300 mm rangeNORMAL resolution mode: less than 2 mm HIGH resolution mode: less than 1 mm Beam Angle (-3dB full angle) 15 ± 2Ëš Indicators Emitters have a green LED for dc power ON. Receivers have two LED’s, one yellow and one green. Indications are as follows: Green ON steady: dc power ON Green flashing: output overloaded Yellow flashing: sonic signal received (flash rate is proportional to received signal strength; flash is from full to half intensity). Construction T-style yellow PBT polyester housing with black PBT polyester back cover. Transducer housing is threaded M18 x 1. Mating jam nut is supplied for mounting. Acoustic face is epoxy reinforced. Circuitry is epoxy-encapsulated. Rated NEMA 6P, IEC IP67. ConnectionsEmitters: 2 m long attached PVC- covered 2-wire cable or 4-pin Euro-style quick-disconnect fitting. Receivers: 2 m long attached PVC-covered 4-wire cable or 4-pin Euro-style quick-disconnect fitting.9 m long cables are available by request. Mating Euro-style quick-disconnect cables are also available. See page 380. Operating Temperature -40° to +70° C Vibration and Mechanical Shock Certifications Meets Mil.Std 202F requirements.Method 201A (Vibration: frequency 10 to 60 Hz, max., and double amplitude 0.06-inch, maximum acceleration 10G). Method 213B conditions H&I (Shock: 75G with unit operation; 100G for non-operation) Also meets IEC 947-5-2 requirements: 30G, 11 milliseconds duration, half sine wave.
MEASUREMENT & INSPECTION Hookup DiagramsEmitter Models: MI22 (p. 497) NPN Models: MI20 (p. 496) PNP Models : MI21 (p. 497)

310

More information online at

bannerengineering.com