| | | | |
| | SLC1 Specifications | |
| | Supply Voltage and Current | 10 to 30V dc (10% max. ripple) @ less than 60 mA (exclusive of load ) | |
| | Supply Protection Circuitry | Protected against reverse polarity and transient voltages | |
| | Power-Up or Reset Delay | 1 second typical (outputs are non-conducting during this time) | |
| | Output Configuration | Bipolar: one current-sourcing (PNP) and one current-sinking (NPN) open-collector transistor | |
| | Output Rating | 150 mA max. (each output) OFF-state leakage current: less than 5 mA @ 30V dc Output saturation voltage: less than 1V @ 10 mA dc; less than 1.6V @ 150 mA dc | |
| | Output Protection Circuitry | Protected against continuous overload and short-circuit of outputs Overload trip point: > 200 mA, typical, at 20° C | |
| | Output Invert Control/Reset | Gray wire has dual functionality, and may be controlled by a PLC Input impedance: 10 Ki> Outputs ON during gap (turn OFF at leading edge of label): leave open, or connect to 0 to +1V dc Outputs ON during label (turn ON at leading edge of label): connect to +5 to 30V dc Microprocessor reset: toggle gray wire to opposite polarity for > 100 milliseconds (see Hookups, page 491) | |
| | Registration Accuracy* | ±0.3 mm typical, web speeds up to 1.5 m per second | |
| | Maximum Web Speed* | 10 m per second | |
| | Response Time* | 100 microseconds | |
| | Minimum Sensing Speed* | 100 mm per minute | |
| | Maximum Switching Speed* | 1 kHz | |
| | Minimum Gap or Label Size | 2 mm | |
| | Adjustments | No user adjustments; automatic continuous adjustment of sensing threshold and drift compensation under internal microprocessor control Adjustment interval: every 250 milliseconds or 4 labels, whichever is greater | |
| | Indicators | Two LEDs, green and yellow: Green ON steady: power to sensor is ON Green flashing @ 4 Hz: output is overloaded Yellow ON steady: NPN and PNP outputs are ON Green and Yellow flashing alternately @ 1 Hz: internal error; reset sensor | |
| | Construction | Housings are machined aluminum with black anodized finish | |
| | Environmental Rating | IP67; NEMA 6 | |
| | Connections | 2 m or 9 m 5-wire attached cable, or 5-pin Euro-style quick-disconnect fitting; cables for QD models are purchased separately. See page 382. | |
| | Operating Conditions | Temperature: +5° to 50° C Relative humidity: 90% at 50° C, non-condensing | |
| | Certifications | C€ | |
| | Hookup Diagrams | SP10 (p. 491) | |
| | | | |