| | | | |
| | Supply Voltage and Current | 10 to 30V dc (10% max. ripple) at less than 45 mA, exclusive of load | |
| | Supply Protection Circuitry | Protected against reverse polarity and transient voltages | |
| | Output Configuration | Bipolar: One current sourcing (PNP) and one current sinking (NPN) open-collector transistor | |
| | Output Rating | 150 mA max. each output at 25° C, derated to 100 mA at 70° C (derate «1 mA per ° C) OFF-state leakage current: less than 5 uA @ 30V dc ON-state saturation current: less than 1V @ 10 mA; less than 1.5V @ 150 mA | |
| | Output Protection Circuitry | Protected against false pulse on power-up and continuous overload or short-circuit of outputs | |
| | Output Response Time | Sensors will respond to either a "light" or a "dark" signal of 500 microseconds (or 150 microseconds, depending on model) or longer duration, 1 kHz max. NOTE: 1 second delay on power-up; outputs are non-conducting during this time. | |
| | Repeatability | 100 microseconds or 75 microseconds, depending on model | |
| | Adjustments | Push-button TEACH-mode sensitivity setting; remote TEACH-mode input is provided (gray wire) | |
| | Indicators | Two LEDs: Yellow and Bicolor Green/Red Green (RUN Mode): ON when power is applied Flashes when received light level approaches the switching threshold Red (TEACH Mode): OFF when no signal is received. Pulses to indicate signal strength (received light level). Rate is proportional to signal strength (the stronger the signal, the faster the pulse rate). This is a function of Banner's patented Alignment Indicating Device (AID™). Alternating Red/Green: Microprocessor memory error Flashing Yellow (Static TEACH): ON to indicate sensor is ready to learn output ON condition OFF to indicate sensor is ready to learn output OFF condition Yellow (Dynamic TEACH): Pulses at 0.5 Hz when ready to sample ON to indicate Dynamic TEACH industrial sampling OFF to indicate sampling was accepted Yellow (RUN Mode): ON when outputs are conducting | |
| | Construction | | |
| | Environmental Rating | NEMA 6; IEC IP67 | |
| | Connections | PVC-jacketed 5-conductor 2 m or 9 m unterminated cable, or 5-pin Euro-style quick-disconnect (QD) fitting are available. QD cables are ordered separately. See page 382. | |
| | Operating Conditions | Temperature: -20° to +70° C Relative humidity: 90% at 50° C (non-condensing) | |
| | Application Notes | The first condition presented during TEACH mode becomes the output ON condition. | |
| | Certifications | C€ | |
| | Hookup Diagrams | DC11 (p. 478) | |
| | | | |