Catalogues - safety-modules

Catalogue Safety Modules

www.bannerengineering.com

Page

/ 30

Make a request

/ 30

See other catalogues for BANNER

Text version of the page

SAFETY MODULES

PICO-GUARD' Controllers

PICO-GUARD™ Interfacing Products (cont'd)

Product Information

Data Sheet

Models ■

Description

Mechanically Linked Contactors

> Pairs of contactors create safety stop circuits with two normally open contacts in series.

> PICO-GUARD can monitor the circuit because of the contacts' force-guided mechanically linked design.

> Contactors add 10 or 16 amp current carrying capability to any safety system.

> Auxiliary contacts add 3 or 4 normally open

contacts.

> Suppressors extend the life of an actuating device that uses a contactor.

> Modular design simplifies assembly and

installation.

11-BG00-31-D-024

11-BF16C01-024

Aux. Contacts

Page 186

111881

11-BGX10-40

11-G484-30

Suppressors

LLI _l

Q O S

>-I-

LLI LL.

11-BGX77-048

11-G318-48

PICO-GUARD™ Remote Display

Data Sheet

PICO-GUARD CONTROLLERS

Models

Description


ñ		• The display provides the same ongoing operating status feedback as the PICO-GUARD controller.
ñ	SFA-RD	• Rated IEC IP67; NEMA 6, it can be conveniently mounted outside enclosure.	109374
II		• Convenient DIN-rail mountable housing; flat-mount and right-angle brackets are included.

E-STOP/GUARD MONITORING

SAFETY MAT

MONITORING

MUTING MODULES

EXTENSION MODULES

INTERFACE MODULES


	PICO-GUARD™ Controller Specifications
	System Power Requirements*	24V dc ±15%, 10% max. ripple; 250 mA max., exclusive of output loads.
	Short Circuit Protection	All inputs and outputs are protected from short circuits to +24V dc or dc common.
	Response Time	Optical Channel: 13 milliseconds max. (Time between the opening of an optical switch and the OSSD safety outputs turning off.) USSI Inputs: 7 milliseconds max. (Time between actuation of the safety stop input device and the OSSD safety outputs turning off.)
	Safety Rating	Type 4 per IEC 61496-1; Category 4 per ISO 13849-1 (EN 954-1).
	External Device Monitoring (EDM) Input	Two inputs for external device monitoring (EDM). Each input industrial monitors the status of a normally closed, forced-guided monitor contact of an external safety device or MPCE. The EDM inputs must be high (10 to 30V dc) when the external device or MPCE is OFF, and must be low (less than 3V dc) when the external device or MPCE is ON. External devices or MPCEs must meet certain timing requirements, depending on the configuration setting.
	System Reset Input	The Reset input must be high (10 to 30V dc) for 0.25 to 2 seconds and then low (less than 3V dc) to reset the system from a manual power-up, optical channel latch or system lockout condition.
	USSI 1 Reset Input	The Reset input must be high (10 to 30V dc) for 0.25 to 2 seconds and then low (less than 3V dc) to reset the system from a USSI 1 latch condition.

' External supply must be In accordance with IEC 61558 (EN 60742).

110 More information online at bannerengineeringXCITI