SAFETY MODULES

E-Stop and Guard Monitoring Modules

GM-FA-10J Guard Monitoring Module Specifications

Supply Voltage and Current 24V ac/dc ± 20% Power consumption: approx. 3 VA / 3 W Supply Protection Circuitry Protected against transient voltages and reverse polarity Output Configuration Each normally open output channel is a series connection of contacts from two forced-guided (mechanically linked) industrial relays, K1-K2. Contacts: AgNi, 5 µm gold-plated Low Current Rating: Caution: The 5 µm gold-plated contacts allow the switching of low current/low voltage. To preserve the gold plating on the contacts, do not exceed the following max. values at any time: Min. voltage: 1V ac/dc Max. voltage: 60V Min. current: 5 mA ac/dc Max. current: 300 mA Min. power: 5 mW (5 mVA) Max. power: 7 W (7 VA) High Current Rating: If higher loads must be switched through one or more of the contacts, the minimum and maximum values of the contact(s) changes to: Min. voltage: 15V ac/dc Max. voltage: 250V ac/dc Min. current: 30 mA ac/dc Max. current: 6 A Min. power: 5 W (5 VA) Max. power: 200 W (1,500 VA) Mechanical life: 50,000,000 operations Electrical life: 150,000 cycles typical, @ 200 W (1,500 VA) switched power, resistive load Note: Transient suppression is recommended when switching inductive loads. Install suppressors across load. Never install suppressors across output contacts.Output Response Time
SAFETY MODULES 35 milliseconds
PICO-GUARDCONTROLLERS Input RequirementsInput switch must have a normally closed contact and a normally open contact capable of switching 5 to 50 mA @ 15 to 30 V dc.
E-STOP/GUARDMONITORING Reset switch must have one normally open contact capable of switching 5 to 50 mA @ 15 to 30V dc. Max. external resistance between terminals S11/S12, S11/S13, S21/S22 and S21/S23: 270
SAFETY MATMONITORING each. Simultaneity Monitoring2-Channel operation: 3 seconds
MUTINGMODULES 1-Channel operation: infinite Status Indicators4 green LEDs: 1 red LED: Construction Polycarbonate housing
EXTENSIONMODULES Environmental Rating Power: power is supplied to Safety Module Fault Channel 1: inputs satisfied (guard closed) Channel 2: inputs satisfied (guard closed) Output: K1 and K2 energized, safety outputs closed Rated NEMA 1; IEC IP40, Terminals IP20
INTERFACEMODULES Mounting Mounts to standard 35 mm DIN rail track. Safety Module must be installed inside an enclosure rated NEMA 3 (IEC IP54), or better. Vibration Resistance 10 to 55 Hz @ 0.35 mm displacement per IEC 68-2-6 Operating ConditionsTemperature: 0° to +50° C Relative humidity: 90% @ +50° C (non-condensing) Safety Category 4 per ISO 13849-1 (EN954-1) (depending on application) Certifications For a list of certifications see page 237. Wiring Diagrams1-Channel Coded Magnet Switches: WD043 (p. 271) 2-Channel Positive Opening Switches: WD044 (p. 271) 1-Channel (Multiple Guards): WD045 (p. 272) 2-Channel (Multiple Guards): WD046 (p. 272) Guarded Machine: WD047 (p. 274)

114

More information online at

bannerengineering.com