| | | | |
| | Sensing Beam | «(¡¡¡¡«¡•W ™ÍFÍbe'°PtÍ<: mÍ'":""rarEd'ViSib'e Re"' "m | |
| | Supply 1/01 lag e and Current | 10 lo 30V dc (10% mal. ripple) at less lhan: Opposed modi;; 30 rrillisrrps ..einllei: 1C inilianips (receiver) Short-range dilluse and relrorellective models: 20 milliamps Filler optic models: 30 milliamps Adjustable-lie Id models: 50 milliamps Fixed-Held and long-range diffuse models: 40 milliamps | |
| | Supply Proleclinn Circuilry | Protected against reverse polarity and transient voltages | |
| | Output Configuration | Solid-state complementary (SPOT); choose NPN (current sinking) dí PNP (current SDiircing) models | |
| | Output Haling | 100 rriA max. (each output) Oft-stale leakage current: less lhan 5 mA at 30V dc On-state saturation voltage: less than Wat 10 mA dc: less than 1.5V at 100 mAdc | |
| | | Protected againsl false pulsa on power-up and continuous overload or short circuit ot outputs Ovedoad trip point > 150 mA, typical, al 20" C | |
| | Dutpul Response Time | Opposed: 1 millisecond on. 05 millisecond off Diffuse, Relrorellective and Adjustable-fieId and Fixed-field: 1 millisecond ON/OFF: Plastic Fiber Optic: 0.25 millisecond ON/OFF NOTE: 1D0 millisecond delay on power-up; outpuisare non-conducling during this time. | |
| | Repeatability | Opposed: 120 microseconds: Dilluse. Relrorellective and Adjiislanle-field and Fixed-field: 250 microseconds; | |
| | Sensing Hysteresis | For Long-range diffuse models; less waa HP. ol set raising distance For Ad¡ustable-tield models; ess Miar i"' i oí sel culoff distance FnrFked-lield mudéis: 2000 mm mode s ■ ess har 5'-. ai sel culoff distance 1500 mm modes ■ ess liar T■ r>! set cutoff distance -mi ■nodels - less than 2% of set cutoff distance 500 mm models - less than 1% of setcutofl dimanes | |
| | Cutnlt Point Tolerance | For FIxBd-lield models only: ,10% of nominal cutoff distance | |
| | | | |